IP816A-LPC-v2
License Plate Capturing Solution
Highway & Street
Installation Guide
Rev. 1.0
Document part no.: 625041100G
Ordering part no.:
IP816A-LPC-v2 (Highway): 199002900G
IP816A-LPC-v2 (Street): 199002800G
IP Surveillance
CAUTION:
TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE COVER.
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
UNPACKING:
Unpack carefully. Electronic components can be damaged if improperly handled or
dropped. If an item appears damaged in shipment, place it properly in its carton and
notify the shipper.
IMPORTANT!:
1. Read and follow Instructions: All operating and user instructions should be read and
followed before the unit is to be operated.
2. Electrical Connections: Only a qualied electrician is allowed to make electrical
connections.
Specications
I
Model Number LPC enclosure
Power Input 24V AC
Max. Output power budget 48W (Street); 80W (Highway)
Power Consumption Window heater: 10W; Blower: 2W; Camera: 6 ~ 8W
Environmental Operation Temp. -20°C ~ +50°C (-4°F ~ +149°F)
Protection Level IP68, IK10
Mounting Bracket Fully-cable Management
Construction Die-cast Aluminum Alloy
Coating White epoxy powder coating
Dimensions 502.8 (L) x 170 (W) x 400 (H) mm
Net Weight 6,482g (9.24 lb)
2
Mounting Conguration & Dimensions
II
Swivel Positions and Directions
English
135.5 mm
158.5 mm
77.4 mm
170
170 mm
105 mm
USABLE
AREA
502.8 mm
400 mm
255 mm
USABLE AREA
502.8
400
3
Component Description
III
Window frame heater
coil
Power distribution
board
Installation Suggestions
IV
M16 1/2" Waterproof cable gland
Ventilation fan
Camera Mounting Platform
If you plan to install this camera enclosure into a tropical, sea coastal, or an environment
where salt water or corrosive industrial waste water/moist are present, please seal each
stainless steel screws and ttings with a silicon grease compounds. This will help prevent
electrolysis to occur and extend the life span of the camera and housing.
IMPORTANT:
1. Disconnect devices: A readily accessible disconnect device in the building installation wiring
should be incorporated.
2. Electrical Connection: Only a qualied electrician is allowed to make electrical connections.
WARNING:
• Please avoid eye exposure or apply appropriate protection, such as wearing a pair of Infrared
protection glasses, when working with the product. Always use camera live view to oberve IR
lighting effects.
4
Installation
V
Install the wall-mount bracket to a preferred location at your installation site. Drill
1.
mounting holes and a cable routing hole (if preferred) on a wall. Install the bracket.
Prepare and route the wiring, Ethernet and 24V power source.
Install the IR illuminator to the bottom of the housing. Attach the included grip stricker
2.
to the U bracket.
English
5
Secure the U bracket to the IR illuminator using the included wrench and hex screws.
3.
Flip the housing over and place it on a clean, stable surface. Secure the IR illuminator
4.
to the bottom of the housing using the included wrench and a hex socket screw.
6