Vivotek AW-IHT-0600, AW-IHT-0601 Installation Guide

AW-IHT-0600 Industrial PoE Switch AW-IHT-0601

Quick Installation Guide

INTRODUCTION

The AW-IHT-0600 series is a rugged media PoE switch designed for delivering a max. of 30 watts to powered devices. The optional TX or FX uplink port can be used to extend the connection to a remote site. With its multi-purpose design, it is t for IP surveillance, trafc monitoring, and security applications in critical environments. The machine features a total budget of 126 watts and a wide range of operating temperatures ranging from -40°C to 75°C.

PACKAGE CONTENTS

* 1x PoE switch * 1x Quick Installation Guide * 1x 6-pin terminal block * 2x wall mount brackets * 1x DIN rail bracket

IMPORTANT:

1. Install the switch in a ventilated and dry place that is free of electromagnetic source, vibration, moisture, and dust.

2. Make sure the ventilation openings on the switch are not blocked.

3. Use ber optic cables and transceiver compliant with the following: Multi-mode: 50/125um, 62.5/125um, 850nm; Single-mode): 9/125um ,1310nm.

4. DC input: (AW-IHT-0600 - 44V~56VDC; AW-IHT-0601 - 12~56VDC). Follow the printed polarity for V+, V-, and Ground.

CONNECTION

1. Pull out the 6-pin terminal block.

2. Connect positive wires to V+, negative wires to V-, and

neutral wire to the ground screw.

Connect the 24V@1A pins to external devices. When 2

power pins are connected, the relay is shorted. When

any of them is diconnected, the relay connection is open.

3. Connect SFP transceivers and ber cables to the ber

ports.

4. Install the 6-pin terminal block.

WARNING - Always ground the power source to maintain a clean power input.

F5 1000M

1 2

T5 100M

LAN/WAN

IMPORTANT - You can either use the F5 ber or the T5 Ethernet port. These ports can not be

used at the same time. Use the DIP switch to make the selection.

Note that the conguration change only takes effect after a power cycle.

DIP 1 F5 Enable the F5 ber port (default)

T5 Enable the T5 Ethernet port

DIP 2 1000M ber port in the Gigabit mode

100M ber port in the 100Mbit mode

LED DEFINITIONS

PW1 ON When power is connected. PW2 ON When power is connected. ERR (relay) ON When both PW1 and PW2 are

connected.

OFF Only PW1 or PW2 is connected.

F5 ON Port 5 ber is detected.

OFF Port 5 ber is not detected. Flashing Data is being transmitted or received.

F6 ON Port 6 ber is detected.

- OR -

Link ON TX link is detected.

SPD ON 1000M speed is detected.

P1,P2,P3,P4ON PD is detected on the designated port.

OFF Port 6 ber is not detected. Flashing Data is being transmitted or received.

OFF Link is not detected. Flashing Port is active.

OFF 10/100M speed is detected.

OFF No PD is detected.