Vivotek AM-71C Installation Guide

VIVOTEK Mounting Accessories

AM-71C Conduit Box

Installation

II

Remove the top cover and unhook the tether wire.

A 3/4" conduit is required for routing the cables with waterproof
connection.

2

Installation Guide

Revison History:

Compatible cameras/brackets

A
B
C

Mounting Dimensions

Rev. 1.0: Initial release

Compatible VIVOTEK Cameras

I

: IT9360-H, IT9380-H
: IB9389 series, IB9360-H, IB9380-H, IB9368-HT, IB9388-HT
: FD9360-H, FD9380-H

Part no.: 625055100G

Accessory Ordering part no.: 100220500G

Package Contents

x4 x4

1

Install the cable gland and pass cables through it.

If using the bottom hole,
seal the center hole.

OR

x4

Attach the included alignment sticker to a preferred position.

3

Drill holes on the wall and install the junction box. If space
behind the wall allows, you may also pass cables through the
wall.

Pass the camera's Ethernet cable through the center hole of

5

the box and the rubber seal.

Loosen and remove the camera top cover. (Using one of

4

the supported cameras as an example)

Install the waterproof components of the cable gland to your

6

Ethernet cable following the QIG of your camera. The cable
gland will be placed within the protection of the box.

Make sure the rubber seal is properly installed to the center

7

hole. The outer rim of the seal must be through and cover the
edge of the hole.

5.5 ~ 6mm

Secure the top cover by fastening 4 hex socket screws.

9

3/4”

A

: IT9360-H, IT9380-H

8

B

: IB9389 series, IB9360-H, IB9380-H, IB9368-HT, IB9388-HT

C

: FD9360-H, FD9380-H

Install the camera using the corresponding mounting holes with

10

the included hex socket screws.

5.5 ~ 6.4mm

Open a live view console and adjust the shooting direction.

11

Refer to the camera's QIG for more information.

If installing a xed dome camera, secure the camera top cover.