Viking DFB Installation Manual
Viking Installation Guide
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information,
call 1-888-VIKING1 (845-4641)
or visit the Viking web site at
vikingrange.com
F20691 EN
DDHK23 Designer Handle Kit
For Use With DFRD Refrigerated Drawers,
DFB Dishwashers, and DFWD171 Warming Drawers
(092309J)
IMPORTANT–Please Read and Follow!
20-21/32”
(52.5 cm)
1-5/8”
(4.1 cm)
13/16” (2.1 cm)
A
A
C
L
3/4” (1.9 cm)
Full Overlay
Panel
3/16” (0.5 cm)
Thru Hole
7/16” (1.1 cm)
Counter Bore x 1/2”
Depth (max)
13/16”
(2.1 cm)
• Before beginning, please read these instructions completely and carefully.
• Use caution during assembly to minimize scratches.
• Do not remove permanently affixed labels, warnings or plates from the product. This may
void the warranty.
• Please refer to the DFRD, DFB and DFWD Installation Instructions for more information on
installing the door panel.
• The installer should leave instructions with the customer who should retain for local
inspector’s use and future reference.
Installation with Wooden Full Overlay
Custom Door Front
Handle Installation
DFRD - REFRIGERATED DRAWER
CUSTOM FRONT DIMENSIONS
Parts Included
Part Quantity
Designer Handles
End Caps
#10 x 3/4” Hex Head Screws
Installation Instructions
Required Tools
Electric Drill
3/16” (0.5 cm) Drill Bit
7/16” (1.1 cm) Spade or Forstner Bit (Counterbore)
Tape Measure
Hex Head Screw Driver
Masking Tape and Pencil
(1)
(2)
(4)
To Install:
1. Locate the wooden custom panel.
2. Using the illustrations on the next page, layout the handle location on the panels. It is
recommended that masking tape be placed where the four holes will be drilled to help mark
the hole placement and to prevent any damage to the door when drilling the holes.
3. The Designer handle will be mounted using (4) of the #10 x 3/4” Hex head screws provided.
Using the 3/16”(0.5 cm) drill bit, drill completely through the door in the hole locations.
Using the 7/16” (1.1 cm) bit, counter-bore four holes 1/2” (1.2 cm) deep max. on the
BACKSIDE of the custom door panel.
4. Attach the Designer handle to the panel using (4) #10 x 3/4” screws provided.
Section A-A
Note: Refrigerated drawers require two handle kits.
2
3
Loading...