Vertex Standard FTM-350R-E - SOFTWARE UPDATE PROCEDURE 1-10-11, FTM-350R/E Update Manual

Jan 10, 11

FTM-350R/E (EXP/EU) Software Update Procedure

Currently we have three different destination versions USA, AUS and EXP/EU of the
FTM-350R/E. Please open the help file and review the information before starting the
update software.

You must check the version radio you have and use the correct update software.
The destination is marked on the box serial number label. See the below label example
for USA destination. If the box in not available, the country you purchased the radio in
may indicate the destination. If the FCC part 15 rules statement is on the radio above the
Serial/ID label, it is the USA version. Other versions will not have the FCC label.

DST: USA version covers North and South America (FTM-350_v13(USA).zip)
DST: AUS version covers Australia and New Zealand (FTM-350_v13(AUS).zip)
DST: EXP/EU

covers all other countries (FTM-350_v13(EXP).zip)

CAUTION

:

Please be sure to confirm the model and the version of your transceiver before starting

the update. Writing incorrect firmware to the transceiver may cause abnormal operation

or failure.

If you have any problems or questions please contact Vertex Standard, [e-mail]
Amateur Tech Support.

Vertex Standard USA, Inc. | 10900 Walker St. | Cypress, CA 90630 | 714.827-7600 | FAX: [phone]

www.vertexstandard.com

Field Code Changed