It is important that you read, fully understand, and observe the following
safety precautions and warning. Read these instructions periodically. Careless or improper use of your Venta Airwasher may cause serious or even fatal
injury. Keep this User Manual with your Airwasher. Be sure anyone using your
Airwasher understands the information contained in this manual.
• Children should not operate the Airwasher.
• Always switch the motor o and unplug the switching power supply from the
AC outlet before lling it with water, adding Venta Water Treatment Additive,
Venta Cleaner, Venta Aromatherapy, or before moving/handling the unit.
• Plug into 110-120 V AC outlet only. Do not use your Airwasher if the switching power supply or plus is damaged. Do not replace a damaged switching
power supply or plug. Only Venta may replace the switching power supply
or plug.
• The Airwasher can only be operated with the Model No. BI13-240050-CdU
switching power supply (included).
3
• Do not attempt any repair work. Maintenance or servicing the Venta
Airwasher, other than described in this use manual, should only be done by
Venta. Any modication to your Airwasher is extremely dangerous and voids
your warranty.
• Do not insert any objects into the air intake of the unit. It may damage the
fan blades or cause injuries. After the motor is switched o, the fan continues to rotate for a short period of time.
• Do not use or store where it can fall or be pulled into a bathtub, sink,
water, or other liquid. Do not reach for a unit that has fallen into water or
other liquid. Do not immerse in water or other liquid, even when the unit is
unplugged or o. Moisture can cause an electric shock hazard when the
unit is again plugged into the AC outlet. Wipe moisture o the unit with a dry
cloth. Do not handle the switching power supply or the unit with wet hands.
• Use only genuine Venta Aromatherapy. Using non-Venta Aromatherapy will
void the warranty.
Read and follow separate instructions and Warnings for Venta Water Treatment Additive, Venta Cleaner, and Venta Aromatherapy.
Please contact Venta Air Technologies Inc. at 888-333-8218 or
www.venta-usa.com for additional information.
4
Easy Setup Guide
Welcome to the Venta Family!
Setting up your Airwasher is much simpler than you would expect.
Just follow these 7 steps and your Airwasher will be up-and-running
in less than 10 minutes!
1. Unpacking
First things rst, remove bottle(s) of Water Treatment
Additive from the corner of your packaging. Keep these
handy as you’ll need them in a bit. Unpack your Airwasher
setting the Styrofoam aside. You may want to return the
Styrofoam to the box and keep the box for any future
Airwasher storage needs.
2. Opening the Airwasher
2
11
2
Open the top of your Airwasher by releasing the tabs on the control panel and
opening the four panels, starting with the non-vented panels.
Lift the motor out of the housing, remove the
power cable, and set it aside for a moment.
On the inside of one of the panels is
a sticker with the serial number on it.
Write this number down as you’ll need
it later!
5
3. Check it Out (Part 1)
Check both the upper housing and the motor for any cracks or damages. If
both are ne, place the motor back inside its housing, making sure to plug it
back in as you do so. Close the upper housing, starting with the vented panels, and clip the tabs. Set the upper housing upside down.
6
4. Check it Out (Part 2)
Remove the disc stack(s) from the lower housing and set
them aside. Remove the protective cardboard from the
upper and lower housings. Check the lower housing and
the disc stack(s) for any cracks or damages. If everything
is ne, put the disc stack(s) back in the lower housing.
Undo the tie holding the power cord and place the upper
housing on the lower housing, guiding the power cord out
through the slot provided.
Please contact Venta Air Technologies Inc. at 888-333-8218 or
info@venta-usa.com if there is any damage to your unit.
5. Set it up
Now it’s time to set up the Airwasher. Find the place where you’d like your
Airwasher to live, making sure to place it properly for best results!
Set the Airwasher there, but don’t yet plug the unit in.
Remove the upper housing from the lower housing and set it aside for a
moment. Take the lower housing over to your sink/bathtub/water source and
ll it with regular tap water up to the water line. Remember the bottle(s) of
Water Treatment Additive? Go grab those and pour them into the water
in the lower housing. Once it’s lled, carry it back over to the upper housing.
Place the upper housing back
onto the lower housing.
7
6. Turn it on
Plug the Airwasher in, press the power button, set the power setting to level
2, and enjoy the fresh air! At power setting 2, the Airwasher will need to run
continuously for about 5 days to properly condition the room it is in. After that,
you will notice the full impact of the Airwasher upon the air in your home!
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.