Vectronics VEC-422KC Instruction Manual
VEC-422KC Assembly
Manual
To install your SCA
instructions
1.
from the adhesive side)
2.
3. Install the two 1/2" mounting screws next. Insert the screws, from the bottom,
4.
5.
6.
7.
8.
9.
10.
(read all instructions before beginning... take your time):
Find the front panel decal and rear panel decal; separate using scissors. Be sure
to leave excess decal material around the edges. Put the rear panel decal on
first.
This is done by:
should be done using a piece of cloth and alcohol. b.) Remove the crack and
peel to expose the adhesive.
securing it completely. d.) Gently rub the alignment circles with your finger--if
the circles are centered in the enclosure holes (also check the corner alignment
marks) secure the decal by rubbing and removing all air bubbles. e.) If the
alignment circles are not centered, adjust the decal accordingly then secure.
f.)
Use a penknife, or small ExactoTM knife, to cut away the unused edges
description side). g.)
Next, install the two L-brackets on the chassis using two of the 3/16" screws.
The longer side of the L-bracket must be connected to the chassis using the two
holes centered on each edge of the enclosure. Refer to the diagram on the next
page for location and orientation.
through the four holes relatively close to each corner of the chassis.
Place the two 3/16" round spacers on the mounting screws.
Now insert the PC board. This must be done by: a) Remove the nuts and
washers from R16 and R17. b.) Insert the front of the PC board at an angle, so
the controls enter their respective holes. c.) Push down on the rear of the board.
Make sure the mounting screws align with the mounting holes in the PC board
before pushing.
Use the two hex nuts to secure the PC board.
components are centered with the enclosure holes before tightening.
washers and nuts--removed from R16 and R17--back on and tighten.
Find the knobs and switch cap. Align the switch cap with SW 1 and push it on.
If it is difficult to push on, then rotate it 90° and try again.
on R16 and R17. You may need to loosen the set screw. Align appropriately
then tighten the set screw.
Locate the piece of double-sided tape. This is to be used for holding the 9-volt
battery clip in place. Locate a place on the underside of the top cover where the
battery will not interfere with any components. Peel off the backing of the tape
and stick it to the chosen location, then install the battery clip.
The top should be installed next.
securing the top to the L-brackets.
properly.
Finally, place the four rubber feet on the bottom of the enclosure at the corners.
Decoder
in the VEC-422KC matching enclosure follow these
a) Remove all debris and oil from the chassis. This
c.)
Place the decal on the rear panel without
and cut out the component holes
Repeat this procedure for the front panel.
Use the two remaining .3/16" screws for
Make sure the L-brackets are aligned
Be certain all appropriate
SCA Decoder Kit
(cut from the
Put the
Now put the knobs
(cut
VEC-422KC Assembly
Manual
SCA Decoder Kit
2
,
Loading...