Vaisala MGP260 Quick Start Guide

Vin +

Vin −

D +

D −

GND

RS-485

M212538EN-A

Quick Guide

Connecting MGP260 probes to Vaisala Insight PC software

USB Service Cable 257295

Connecting MGP260 probes to Insight with USB service cable

• Computer with Vaisala Insight PC software installed (www.vaisala.com/insight)

• USB service cable 257295

• Small ﬂat head screwdriver for opening the screw terminal block screws

WARNING!

area. Remove the probe from the process for conﬁguration, and use only the Vaisala accessory PC connection cable 257295 to connect the probe to Insight.

To connect to Insight with USB service cable:

1. Plug the USB cable into your computer and install the USB cable driver as instructed in Installing

the Driver for the USB Service Cable (page 2).

2. Open the Insight software.

3. Open the MGP260 connection box: for instructions, see the probe user documentation.

4. Unscrew the 6-pin screw terminal block on the MGP261 component board and lift the block out.

5. Plug the USB cable into the open port as shown in the illustration above.

6. Wait for Insight software to detect the probe.

For more information on wiring MGP260 and using and MGP260 User Guide (available at www.vaisala.com/mgp260).

The PC software connection cable must be used only outside the explosion hazardous

conﬁguring MGP260 with Insight, see

PUBLISHED BY Vaisala Oyj Vanha Nurmijärventie 21 FI-01670 Vantaa, Finland © Vaisala Oyj 2020

All rights reserved. Any logos and/or product names are trademarks of Vaisala or its individual partners. Any reproduction, transfer, distribution or storage of information contained in this document is strictly prohibited. All speciﬁcations — technical included — are subject to change without notice.

Quick Guide M212538EN-A

Installing the Driver for the USB Service Cable

Only Windowsâ operating systems are supported by the driver of the USB service cable.

1. Connect the USB service cable to a USB port on your computer. Windowsâ detects the new device and installs the appropriate driver.

2. Open Devices and Printers from the Windowsâ Start menu. Use search to ﬁnd it if necessary (search for "devices").

3. Locate the cable in the list of devices:

• If the device is listed as Vaisala USB Device with a COM port number in brackets, the cable is

ready for use. Take note of the COM port number for later use.

• If the device is listed as Vaisala USB Instrument Cable without a COM port number listed,

you must install the driver manually.

4. To install the driver manually: a. Disconnect the USB service cable from the computer. b. Download the Vaisala USB driver at www.vaisala.com/software (search and select the

appropriate USB Instrument Driver Setup for your cable).

c. Run the USB driver installation program Vaisala USB Device Driver Setup.exe.

Accept the installation defaults.

d. Go back to step 1 and verify that the driver installation works as expected.