Ubiquiti UVP-Pro UniFi Quick Start Manual
Enterprise VoIP Phone with
5" Touchscreen, Bluetooth,
WiFi, and Built-In Camera
Model: UVP-Pro
Introduction
Thank you for purchasing the UniFi® VoIP Phone Professional,
model UVP-Pro. Designed to integrate easily into a UniFi
network, the interface is based on the popular Android™
platform for ease of use. This Quick Start Guide is designed to
guide you through the installation, provide an overview of the
interface, and also includes the warrantyterms.
Package Contents
Enterprise VoIP Phone with
5" Touchscreen, Bluetooth,
WiFi, and Built-In Camera
Model: UVP-Pro
UniFi VoIP Phone Professional Quick Start Guide
Installation Requirements
• UniFi Switch or PoE+ (802.3at-compliant) switch
• UniFi Controller
• UniFi Security Gateway
Note: The PBX functionality in the UniFi Security Gateway only
supports the English language. If you need to support other
languages (e.g. for your voicemail), a third-party PBX or SIP/PBX
provider is required.
TERMS OF USE: All Ethernet cabling runs must use CAT5 (or above). It is the customer’s
responsibility to follow local country regulations and indoor cabling requirements.
Before You Begin
Remove the protective
covering from the handset.
Remove the protective film
from the touchscreen.
Hardware Overview
Front
Camera
LED
Touchscreen
Volume
Camera Built-in camera can be used for snapping photos for
avatars or videoconferencing applications.
Touchscreen The 5" (diagonal) touchscreen display is used for
all interface navigation and dialing.
Volume Use the volume arrows to adjust audio levels.
LED The LED will illuminate when the device is first connected
to a 48V power source. Once the phone has started up, the
LED will turn off.
IMPORTANT: The LED will flash when a firmware update
is occurring. Do not disconnect power/Ethernet from the
device during this time.
Back Ports
PoE/LAN PC
PoE/LAN
PC
PoE/LAN The PoE/LAN Ethernet port is 802.3at-compliant
and is used to connect data and power to the phone. Connect
this port to the same network as the UniFi Security Gateway
VOIP port.
PC The Ethernet port labeled PC is used for bridging.
WARNING: Do not connect a powered Ethernet
connection to the port labeled PC.
Side Ports
Micro-USB Port The Micro-USB port is only
intended for advanced users connecting the phone
to a computer.
Headset Jack 3.5 mm jack for optional wired stereo
and microphone headsets.
Handset
Mute button
Mute Press the Mute button to mute the microphone on the
handset.
*640-00143-09*
640-00143-09
Hardware Installation
The UniFi VoIP Phone Professional is designed for desktop
placement. To connect the phone, perform the following steps:
1. Connect one end of an Ethernet cable to the wall jack that
is connected to your 48V, 802.3at-compliant switch.
2. Connect the other end of the Ethernet cable to the port
labeled PoE/LAN on the UniFi VoIP Phone Professional.
PoE/LAN PC
Software Configuration
The UniFi VoIP Phone Professional is automatically detected by
the UniFi Controller (4.6.x or above).
Installing the UniFi Controller
If you haven’t already installed the UniFi Controller software,
you can download it at downloads.ubnt.com/unifi
Adopting the Phone in the UniFi Controller
1. Launch the UniFi Controller and go to the Devices tab.
2. Click Adopt.
Loading...