Ubiquiti Bullet BM2-Ti, Bullet BM5-Ti Quick Start Manual

Zero-Variable Outdoor Radio

Models: BM2-Ti, BM5-Ti

Introduction

Thank you for purchasing the Ubiquiti Networks™ airMAX™
Bullet

™

Titanium. This Quick Start Guide is designed to guide
you through the installation of the radio. This Quick Start
Guide also includes the warranty terms and is for use with the

BulletM2 Titanium, model BM2-Ti, and the BulletM5Titanium,

model BM5-Ti.

Package Contents

Bullet Titanium N-Type Right

Angle Adapter

Zero-Variable Outdoor Radio

Models: BM2-Ti, BM5-Ti

PoE Adapter

(24V, 1A)

Power Cord Quick Start Guide

Products may be different from pictures and are subject to change without notice.

TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable is
designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic
Frequency Selection (DFS) requirements.

Hardware Overview

N-Type

Connector

Bullet Titanium

Radio

Rubber Washer

Cable Gland Body

Compression Nut

Ethernet Port

Compression Seal

Hardware Installation

1. Unscrew the Cable Gland Body and detach it from the Bullet

Titanium Radio.

2. Unscrew the Compression Nut and remove the Compression

Seal from the Cable Gland Body.

3. Slide the Compression Nut over the Ethernet cable with

the threaded end facing the RJ-45 connector. Slip the
Compression Seal around the cable.

4. Feed the Ethernet cable through the Cable Gland Body and

seat the Compression Seal into the Cable Gland Body.

5. Connect the Ethernet cable to the port located on the

bottom of the Bullet Titanium Radio.

6. Securely screw the Cable Gland Body into the Bullet

Titanium Radio so that the Rubber Washer seals the bottom

of the radio.

7. Tightly screw on the Compression Nut. Ensure the

Compression Seal is securely compressed and tightly sealed
around the cable.

8. Connect the Bullet Titanium to the N-Type connector of

the antenna.

Note: The Bullet Titanium should be mounted

vertically to reduce stress on the N-Type Connector.
The N-Type Right Angle Adapter may be used as
needed.

Connecting Power over Ethernet

1. Connect the other end of the Ethernet cable from the

Bullet Titanium to the Ethernet port labeled POE on the

PoE Adapter.

2. Connect an Ethernet cable from your LAN to the Ethernet

port labeled LAN on the PoE Adapter.

3. Connect the power cord to the power port on the PoE

Adapter. Connect the other end of the power cord to a
power outlet.