Ubiquiti BDBAC Users Guide

Bullet AC IP67 N-Type Right Angle Adapter

Package Contents

Installation Requirements

Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor
wired Ethernet connections and should be grounded through the AC ground of the
PoE.

We recommend that you protect your networks from harmful outdoor environments
and destructive ESD events with industrial-grade, shielded Ethernet cable from
Ubiquiti. For more details, visit ui.com/toughcable

Surge protection should be used for all outdoor installations. We recommend that
you use two Ethernet Surge Protectors, model ETH-SP, one near the Bullet and the
other at the entry point to the building. The ETH-SP will absorb power surges and
safely discharge them into the ground.

* Shown without antenna.

Hardware Overview

BulletAC-IP67 Quick Start Guide

Reset Button

Ethernet Port

To reset to factory defaults, press and hold the Reset button for more than 10
seconds while the device is powered on.

This 10/100/1000 Ethernet port is used to connect the power and should be
connected to the LAN and DHCP server.

Hardware Installation

1.

2.

BulletAC-IP67 Quick Start Guide

3.

4.

5.

BulletAC-IP67 Quick Start Guide

6.

7.

8.

BulletAC-IP67 Quick Start Guide