TRSYS P4SMAJ170C, P4SMAJ170, P4SMAJ16CA, P4SMAJ17A, P4SMAJ18C Datasheet

P4SMAJ SERIES

SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR

VOLTAGE - 5.0 TO 170 Volts	400Watt Peak Power Pulse
FEATURES	SMA/DO-214AC

•For surface mounted applications in order to optimize board space

•Low profile package

•Built-in strain relief

•Glass passivated junction

•Low inductance

•Excellent clamping capability

•Repetition Rate(duty cycle):0.01%

•Fast response time: typically less than

1.0 ps from 0 volts to BV for undirectional types

•Typical ID less than 1 A above 10V

•High temperature soldering :

250 /10 seconds at terminals

• Plastic package has Underwriters Laboratory Flammability Classification 94V-O

MECHANICAL DATA

Case: JEDEC DO-214AC low profile molded plastic

Terminals: Solder plated, solderable per

MIL-STD-750, Method 2026

Polarity: Indicated by cathode band except bi-directional types

Weight: 0.002 ounces, 0.064 gram

Standard packaging:12 mm tape per(EIA 481)

MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS

Ratings at 25 ambient temperature unless otherwise specified.

	SYMBOL	VALUE	UNITS
Peak Pulse Power Dissipation at TA=25 , Fig. 1 (Note 1,2,5)	PPPM	Minimum 400	Watts
Peak forward Surge Current per Fig. 5 (Note 3)	IFSM	40.0	Amps
Peak Pulse Current current on 10/1000 s waveform	IPPM	See Table 1	Amps
(Note 1,Fig 2)
Steady State Power Dissipation (Note 4)	PM(AV)	1.0	Watts
Operating Junction and Storage Temperature Range	TJ,TSTG	-55 to +150

NOTES:

1.Non-repetitive current pulse, per Fig. 3 and derated above TA=25 per Fig. 2. 2.Mounted on 5.0mm2 copper pads to each terminal.

3.8.3ms single half sine-wave, duty cycle= 4 pulses per minutes maximum.

4.Lead temperature at 75 =TL.

5.Peak pulse power waveform is 10/1000 s.

MAXIMUM RATINGS AND CHARACTERISTIC CURVES P4SMAJ SERIES

Fig. 1-PEAK PULSE POWER RATING VERSUS

Fig. 2-PULSE RATING CURVE

Fig. 3-PULSE WAVEFORM

Fig. 4-TYPICAL JUNCTION CAPACITANCE