Treasure Garden AG3 User Manual
AG3
9’
OC
/8’
SQ
Cantilever
Assembly and Operation Guide
B
A
C
L
K
O
P
E
Bolts (8)
Washers (8)
Hex Bolt (1)
Allen Wrench (1)
Crank
Handle (1)
D
F
G
N
I
M
H
J
A - Cross Bars (2) F - Side Arm Lock K - Shoulder
B - Bottom Pole Stem G - Mid-Pole L - Arch Pole
C - Cross Bar Extenders (4) H - Side Arm Pole M - Hinge
D - Set-Up Collar Knob I - Crank Handle N - Spring-Loaded Push Buttons
E - Stop Ring J - Crank Lift Hub O - VEGA
™
Light Adapter
P - Canopy
Thank you for your purchase of Treasure Garden’s AG3 Cantilever Umbrella.
Please remove all contents from the package, inspect and review checklist.
CAUTION: To reduce personal injury and damage to your AG3, read and follow this
assembly and operation guide We recommend a two-person team for assembly and
disassembly. Save information for future reference.
REQUIRED FOR ASSEMBLY:
• One (1) 1/2" socket wrench or adjustable wrench.
• Four (4) 50 lb. weights - square stones or concrete weights. (200 lb. total weight
needed for support - weights not included) Stones & weights, standard sizes
can be used up to 20" L x 20" W x 1.5" H.
NOTE: Using the cross bar stand without weights will damage your umbrella
and may cause injury.
AG3 CHECKLIST
25
(Fig. 1)
(Fig. 2)
Hex Bolt
Axis
Allen Wrench
Crank
Handle
(Fig. 5) (Fig. 6) (Fig. 7)
(Fig. 3) (Fig. 4)
STEP 1 Assemble Universal Cross Bar Stand
Set cross bars in a cross position and attach bottom pole stem (Fig. 1) to cross bar
stand with (4) supplied bolts and (4) washers (Fig. 2). Adjust universal cross bar
stand to accomdate your 16”, 18” or 20” square stones or concrete weights with (4)
supplied bolts and (4) washers. Secure stand with (4) square stones or concrete
weights (weights not included).
IMPORTANT: Cross bar stand will not support umbrella without proper weights.
Using the stand without weights will damage your umbrella.
STEP 2 Assemble AG3 Frame
Insert AG3 mid-pole into bottom pole stem (Fig. 3). Line up holes until spring-loaded push
buttons pop out to lock frame into position (Fig. 4).
STEP 3 Assemble AG3 Handle
Insert the crank handle into the axis (Fig. 5). Lock handle by screwing on the hex bolt (Fig. 6).
Use the allen wrench (provided) to fasten (Fig. 7).
Loading...