Treasure Garden AG19 User Manual

AG19

10’

OC

Cantilever

Assembly and Operation Guide

I

M

P

L

K

J

B

A

G

D

E

F

C

Bolts (4)

Washers (4)

Wrench (1)

R

Q

O

H

N

A - Spring Locks (2) G - Support Strut M - Cantilever Arm
B - Top Pole H - Tilt Degree Scale N - Hinge
C - Crank I - Shoulder O - Vega

™

Light Adapter

D - Operating Handle J - Release Knob P - Canopy
E - Crank Case K - Bottom Pole Q - Cross Bars (2)
F - Steering Rod L - Base Pole Clamp R - Bottom Pole Stem

Thank you for your purchase of Treasure Garden’s AG19 Cantilever Umbrella.

Please remove all contents from the package, inspect and review checklist.
CAUTION: To reduce personal injury and damage to your AG19, read and follow this
assembly and operation guide We recommend a two-person team for assembly and
disassembly. Save information for future reference.

REQUIRED FOR ASSEMBLY:

• One (1) 1/2" socket wrench or adjustable wrench.

• Four (4) 40 lb. weights - square stones or concrete weights. (160 lb. total weight

needed for support - weights not included) Stones & weights, standard sizes
can be used up to 20" L x 20" W x 1.5" H.

NOTE: Using the cross bar stand without weights will damage your umbrella

and may cause injury.

AG19 CHECKLIST

25

Bottom

Pole

Cantilever Arm

Top Pole

with Canopy

Cantilever Shortened*

Stem

Pole

(Fig. 4)

(Fig. 1)

(Fig. 2)

STEP 1 Assemble Cross Bar Stand

Set cross bars in a cross position and attach bottom pole stem (Fig. 1) to cross bar
stand with supplied bolts and washers (Fig. 2). Secure with (4) square stones or
concrete weights (weights not included).

IMPORTANT: Cross bar stand will not support umbrella without proper weights.
Using the stand without weights will damage your umbrella.

STEP 2 Assemble AG19 Frame

Insert the top pole with canopy into the bottom pole until spring locks (Fig. 3). Hold the canopy
closed and slowly lift cantilever upwards until arm is fully extended and spring locks into place
(Fig. 4). Screw the crank handle clockwise into the crank case.

*NOTE: Shortening of the cantilever is merely for packaging purposes or storage.

IMPORTANT: (If cantilever arm does not fully extend, cord maybe coiled too tightly). Two

persons are needed for the following action. While the first person slowly lifts the cantilever up,
the second person turns the crank handle counter-clockwise, releasing more cord to allow the
cantilever arm to raise until spring locks into place.

(Fig. 3)