Trane TR200 MCB 101 Operating Instructions Manual

MCB 101 - General Purpose I/O
Option Module
Operating Instructions

December 2008

TR200

BAS-SVX28A-EN

BAS-SVX28A-EN

Warnings, Cautions and Notices

Note that warnings, cautions and notices appear at appropriate intervals throughout this manual. Warnings are
provide to alert installing contractors to potential hazards that could result in personal injury or death. Cautions
are designed to alert personnel to hazardous situations that could result in personal injury, while notices indicate
a situation that could result in equipment or property-damage-only accidents.
Your personal safety and the proper operation of this machine depend upon the strict observance of these
precautions.

Warnings, Cautions and Notices appear at appropriate sections throughout this literature. Read these carefully.

WARNING

Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION

Indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. It could also
be used to alert against unsafe practices.

NOTICE

Indicates a situation that could result in equipment or property-damage only accidents.

Note
Indicates something important to be noted by the reader.

✮

Indicates default setting

TR200 Series VFD General Purpose I/O Option Module MCB

101 Instruction

1

Introduction

This instruction describes the General Purpose I/O option MCB 101 for use in the TR200 expanding the number
of input/output in the frequency converter.

The MCB 101 option includes 3 digital inputs, 2 analog inputs, 2 digital outputs and 1 analog output.

SW firmware version to be installed in the drive control card must be version 3.00 or later versions for series,
and version 1.1x for TR200 series. Check par.15-43

Software Version for firmware version.

Code Numbers To Be Used At Ordering The Complete Kit For Upgrades

Standard version code no. 130B1125.
Coated version code no. 103B1212.

Illustration 1. 1: Parts for coated/non-coated code nos .

2 TR200 Series VFD General Purpose I/O Option Module MCB 101 Instruction