Toshiba SD-R1612 User Manual
TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
SD-R1612
CD-RW/DVD-ROM COMBO DRIVE
USER MANUAL
CONTENTS
Introduction..............................................................................1
Setup ........................................................................................2
Using the Combo Drive...........................................................3
Troubleshooting.......................................................................5
Specifications ..........................................................................6
Drive Connectors..................................................................... 8
INTRODUCTION – SD-R1612
General Features
CD-R/CD-RW disc write/rewrite at 52X/32X
3-way Disc Eject (eject button, software, emergency eject hole)
Average Random Access Time
CD-ROM/CD-R 95ms
CD-RW 110ms
DVD-ROM - Single 110ms
DVD-ROM - Dual 130ms
DVD-RAM 200ms
Horizontal or Vertical Mount
2MByte Buffer
Playback interchangeability for CD-ROM and DVD-ROM discs
Regionalization (RPC2 compliance) (DVD)
BUS Interface - ATAPI
Media Compatibility
CD
• 650MB CD-ROM (Read)
• 80mm CD (Horizontal Mount Only)
• 800/700/650MB CD-Recordable (Read&Write)
• 700/650MB Low/High/Ultra Speed CD-Rewritable (Read & Write)
DVD
• 5/9/10/18G DVD Single/Dual (PTP, OTP) (Read)
• 3.9/4.7G DVD-ROM
• DVDRW. DVDR , DVD-RAM
• 80mm DVD (Horizontal Mount only)
1
Types of Disc Formats Support – Read
DVD:
• DVD-ROM (Book 1.02)
• DVD-video (Book 1.1)
• DVD-R (Book 1.0, 3.9G)
• DVD-R (Book 2.0, 4.7G) - General & Authring
• DVD+R (Version 1.0)
• DVDRW
• DVD-RAM
CD:
• CD-DA (Red Book)
• CD-ROM (Yellow Book Mode1&2)
• CD-ROM XA (mode 2 Form 1&2)
• CD-I (Green Book, Mode2 Form 1&2, Ready, Bridge)
• CD-EXTRA/CD-Plus (Blue Book)
• CD-R (Orange Book Part II)
• CD-RW: HSRW (Orange Book Part III Volume1&2, USRW)
Front Panel
Loading Tray
LED
Load/Unload
Button
Emergency
Eject Hole
Figure 1.SD-R1612 DVD Writeable Drive Front Panel
Load disc using tray.
The LED lights green or amber when the drive is operating (LED is amber when drive is
writing.)
The Load/Unload button is used to open the disc tray so you can install or remove a disc.
The emergency eject hole is to be used only when the Loading Tray will not open when
Eject button is pressed.
SETUP – SD-R1612
The following steps must be performed to properly install your drive:
• Set Drive Jumper Settings
• Connect Audio Cable
• Attach IDE BUS Cable
• Attach Power Cable
• Mount Drive
Jumper Settings
The mode select jumpers are 6 straight angle pins located on the rear of the Combo drive.
By placing a jumper on the pins, you can select the following functions:
CS
SL Configures drive as Slave
MA Configures drive as Master (default mode)
In most installations, jumper should remain in the MA position (factory default). It is recommended that
you install your Combo drive only on the secondary IDE BUS. If you are installing on primary IDE BUS,
your hard drive would then be the Master, and you should set your Combo drive to the Slave position
(SL)
Drive is configured using host interface signal CSEL
Figure 1.Mode Select Jumper
3
Figure 2.Jumper Locations
Loading...