Toshiba IK-WD12A, Camera User Manual

NETWORK CAMERA

Model: IK-WD12A

Quick Start Guide and Important Safeguards

This guide describes the hardware installation.

Refer to the user's manual (PDF le) contained in the CD-ROM for settings, operations and other information.

The application Adobe Reader is needed to view PDF les. If you do not have this application, download it from the Adobe Systems Incorporated website.

http://www.adobe.com/

For information on our latest products and peripheral devices, refer to the following Website:

http://www.toshibasecurity.com

If the URL changes, refer to the Toshiba website (http://www.toshiba.com).

Introduction

FCC (USA)-INFORMATION

This equipment has been tested and found to comply with the limits for a Class B

NOTE:

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cables must be used in order to comply with emission limits.

USER-INSTALLER CAUTION:

equipment could be voided if you make changes or modications not expressly approved by the party.

Your authority to operate this FCC veried

Thank you for purchasing the IK-WD12A Network Camera. Before you start using the camera, read this quick start guide carefully to ensure correct usage. Once you have nished reading this quick start guide, keep it in a convenient place for future reference.

The design, specications, software, and quick start guide contents are subject to change without prior notice.

Terms and Trademarks

The term "OS" is used in this manual to indicate operating systems compatible

with this product.

-- Windows® XP: Microsoft® Windows® XP operating system

-- Windows Vista

-- Windows 7®: Microsoft® Windows 7® Professional operating system

The formal name of Windows

Microsoft

trademarks of Microsoft® Corporation in the United States and other countries.

is a registered trademark and Adobe Reader® is a trademark of Adobe

Adobe

Systems Incorporated.

Other product names appearing in this quick start guide may be trademarks or

registered trademarks of their respective holders.

: Microsoft® Windows Vista® Business operating system

is Microsoft® Windows® Operating System.

, Windows® and Windows Vista® are trademarks or registered

NOTE

The performance of the network camera may vary depending on the network

environment.

Introduction 2

FCC (USA)-INFORMATION .......................................................................................2

Terms and Trademarks ..............................................................................................3

Table of Contents.............................................................................................. 4

Important Safeguards ....................................................................................... 5

Notes on Use and Installation........................................................................... 8

Setting the Network Camera Environment ....................................................... 9

Items needed for network camera monitoring ...........................................................9

Contents ......................................................................................................... 10

Physical Description .......................................................................................11

Hardware Installation ..................................................................................... 12

Network Deployment ..................................................................................... 13

Assigning IP Address ...................................................................................... 15

Retrieving Images........................................................................................... 16

Adjusting the Lens .......................................................................................... 17

Completion ..................................................................................................... 19

Important Safeguards

1. Read Instructions

Read all the safety and operating instructions before operating the product.

2. Retain Instructions

Retain the safety instructions and user's manual for future reference.

3. Warnings

Comply with all warnings on the product and in the user's manual.

4. Follow Instructions

Follow all operating and use instructions.

5. Cleaning

Disconnect this camera from the power supply before cleaning.

6. Attachments

Do not use attachments not recommended by the camera manufacturer as they may pose safety risks.

7. Water and Moisture

Do not use this camera near water. Some examples are: near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.

8. Accessories

Do not place this camera on an unstable cart, stand, tripod, bracket or table. The camera may fall, causing serious injury to a person, or serious damage to the product. Use only with stand, tripod,bracket,or table recommended by the manufacturer, or sold with the camera. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer.

9. Ventilation

This camera should never be placed near or over a radiator or heat register. If this product is placed in a built in installation verify that there is proper ventilation so that the camera temperature operates within the recommended temperature range.

10. Power Sources

This camera should be operated only from the type of power source indicated on the information label. If you are not sure of the type of power supply at your location, consult your product dealer.

11. Power-Cord Protection

Power cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to cords at plugs, screws and the point where they exit the product.

12. Installation

Install this camera on a secure part of the ceiling or wall. If installed on an unsecured location, the camera could fall causing injury and damage.

13. Lightning

For additional protection on this camera during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the power supply and cable system. This will prevent damage to the camera due to lightning and power-line surges. If lightning occurs, do not touch the unit or any connected cables in order to avoid electric shock.

14. Overloading

Do not overload the power supply or extension cords as this can result in a risk of re or electric shock.

15. Object and Liquid Entry

Never push objects of any kind into this camera through openings as they may touch dangerous electrical points or short-out parts that could result in a re or electrical shock. Never intentionally spill liquid of any kind on the camera.

16. Servicing

Do not attempt to service this camera yourself as opening or removing covers may expose you to dangerous electrical or other hazards. Refer all servicing to qualied service personnel.

17. Damage Requiring Service

Disconnect this camera from the power supply and refer servicing to qualied service personnel under the following conditions.

a. When the power-supply cord or plug is damaged.

b. If liquid has been spilled, or objects have fallen into the camera.

c. If the camera has been submerged in water.

d. If the camera does not operate normally by following the operating instructions in the

user's manual. Adjust only those controls that are covered by the user's manual as an improper adjustment of other controls may result in damage and will often require extensive work by a qualied technician to restore the camera to its normal operation.

e. If the camera has been dropped or the cabinet has been damaged.

f. When the camera exhibiting a distinct change in performance which indicates a need for

service.

g. Other trouble.

18. Other trouble. Replacement Parts

When replacing parts be sure the service technician uses parts specied by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in re, electric shock or other hazards.

19. Safety Check

Upon completion of any service or repairs to this camera, ask the service technician to perform safety checks to determine that the camera is in proper operating condition.

+ 14 hidden pages