Thermador VCIB48JP, VCIB54JP, VTN1090R Installation Manual

Integral Blower Installation
Manual

Models | Modèles |
Modelos:

Manuel d’Installation d’un
Ventilateur Intégré

Manual de Instalación de un
Ventilador Integrado

VTN630
VTN1030
VTN1080
VTN1090

Integral Blower Installation

10⅞"
(275)

13⅛"

(335)

8¼"
(208)

18⅞"

(473)

Suitable for the following hood models:

Hood Models Blower

PH36GS, PH42GS, PH48GS, PH54GS,
PH60GS, PH30HS, PH36HS, PH48HS,
VCIB48JP, VCIB54JP, VCIN60RP, VCIB36JP,
VCIN36JP, VCIN48JP, VCIN54JP

inches (millimeters)

4⅛"

(105)

inches (millimeters)

6⅞"

(175)

Integral Blower Model VTN1030

8¼" (210)

8⅞"

(225)

2¼"

(57)

6¾"

(171)

25"

(635)

VTN1030
VTN630
VTN1080
VTN1090

Installation Instructions

Integral Blower models are integrated into the ventilation
hood at the time of installation.

Refer to the Installation Manual for important safety
instructions. Use gloves when installing blower unit.

NOTE: The blower can be installed for horizontal or vertical
discharge only on HS and GS models.

1. The blower is attached to the hood using weld studs
provided on the mounting plate. Guide the motor
mounting plate over the studs.

2. Attach (4) nuts (included with hood) to the weld studs.
Tighten nuts to secure the blower to the hood.

8¼"

(210)

4⅛"

(105)

inches (millimeters)

8¼"

8¼"
(208)

(208)

18⅞"

18⅞"

(473)

(473)

8⅞"

(225)

(635)

6⅞"

(175)

25"

Integral Blower Model VTN630

10⅞"

10⅞"

(275)

(275)

13⅛"

13⅛"

(335)

(335)

Weld Stud Locations

3. Connect the blower’s Molex plug connector to the
connector present inside the hood.

From Blower

From Control Panel

Wiring the Hood with an Integral Blower

Integral Blower Model VTN1080 and VTN1090,

VTN1090 shown

English