Texecom INS326 Installation Manual

Installation Manual

USB-Modem

Issue 2

2 INS236

1 Introduction

The USB-Modem has been specifically designed for use with Wintex UDL
software and a PC to allow trouble free uploading/downloading with Premier
control panels.

System Requirements

The following are the minimum requirements required for the USB-Modem to
work properly with your computer:

• 133 MHz or faster Intel

®

Pentium® or AMD® processor

• 10 MB free hard disk space

• 16 MB RAM (32 MB or higher recommended)

• Microsoft

®

Windows® 98 Second Edition (SE), Windows 2000, Windows

Millennium Edition (ME), Windows XP or Windows Vista

• DVD/CD-ROM drive for modem software installation

USB-Modem Layout

The USB-Modem has only two connectors, one, the USB Connector, and two,
the Telephone Line Jack. No extra power connector is needed as the unit is a
USB-powered device that draws power from the computer’s USB port.

INS326 3

USB Connector

Telephone Line Jack

Power/Data Indicator

Figure 1. USB-Modem Indicators and Connectors

Telephone Line Jack: Connect the telephone supplied into this socket and plug

the other end into a telephone wall socket.

USB Connector: Connect the smaller end of the supplied USB cable into the
USB Connector. Connect the other end into one of the computer’s USB ports.

Power/Data Indicator: This indicator is lit when the USB-Modem is powered
from the USB port. The indicator flickers when the USB-Modem is sending or
receiving data.

4 INS236

2 Installation

USB Driver Installation

The USB-Modem requires a driver to be installed onto the computer before it can
be used. The USB-Modem uses the same driver as the USB-Com, the driver can
be found on the Wintex CD in the D:\USB-Com folder or alternatively it can be
downloaded from the Texecom web site www.texe.com.

If you are already using a USB-Com with the computer then driver will already be
installed and you can skip steps 2 - 7.

! Windows 98SE and Windows ME

1) Connect the USB-Modem into a USB port on the PC. Turn on your

computer to allow the Operating System to detect the USB-Modem.

2) When detected the Add New Hardware Wizard screen appears:

3) If you are using the drivers from the Wintex CD insert the CD into your
DVD/CD-ROM drive. Then click the Specify the location of the driver
(Advanced) option and click the Next button.

4) Click the Specify a location check box. Then, click the Browse button

to locate the driver files in D:\USB-Com\Win98ME (where D:
represents your DVD/CD-ROM drive). Ensure that the Removable
Media (Floppy, CD-ROM…) check box is not selected: