Texas Instruments OP07DP, OP07DDR, OP07CP, OP07CDR, OP07DD Datasheet
VIOmax
CHIP FORM
OP07C, OP07D, OP07Y
PRECISION OPERATIONAL AMPLIFIERS
SLOS099B – OCTOBER 1983 – REVISED AUGUST 1996
D
Low Noise
D
No External Components Required
D
Replaces Chopper Amplifiers at a Lower
Cost
D
Single-Chip Monolithic Fabrication
D
Wide Input Voltage Range
OFFSET N1
D OR P PACKAGE
(TOP VIEW)
1
IN–
2
IN+
3
V
CC–
4
OFFSET N2
8
V
7
CC+
OUT
6
NC
5
0 to ±14 V Typ
D
Wide Supply Voltage Range
±3 V to ±18 V
D
Essentially Equivalent to Fairchild µA714
Operational Amplifiers
D
Direct Replacement for PMI OP07C and
OP07D
description
symbol
NC–No internal connection
IN
IN –
1
3
+
+
2
–
8
OFFSET N1
OFFSET N2
6
OUT
These devices represent a breakthrough in operational amplifier performance. Low offset and long-term stability
are achieved by means of a low-noise, chopperless, bipolar-input-transistor amplifier circuit. For most
applications, external components are not required for offset nulling and frequency compensation. The true
differential input, with a wide input voltage range and outstanding common-mode rejection, provides maximum
flexibility and performance in high-noise environments and in noninverting applications. Low bias currents and
extremely high input impedances are maintained over the entire temperature range. The OP07 is unsurpassed
for low-noise, high-accuracy amplification of very low-level signals.
These devices are characterized for operation from 0°C to 70°C.
AVAILABLE OPTIONS
PACKAGED DEVICES
T
A
0°C to 70°C 150 µV
The D package is available taped and reeled. Add the suffix R to the device type (e.g., OP07CDR). The chip
form is tested at TA = 25°C.
AT 25°C
SMALL OUTLINE
(D)
OP07CD
OP07DD
PLASTIC DIP
(P)
OP07CP
OP07DP
(Y)
OP07Y
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
Copyright 1996, Texas Instruments Incorporated
1
OP07C, OP07D, OP07Y
PRECISION OPERATIONAL AMPLIFIERS
SLOS099B – OCTOBER 1983 – REVISED AUGUST 1996
OP07Y chip information
These chips, properly assembled, display characteristics similar to the OP07. Thermal compression or
ultrasonic bonding may be used on the doped-aluminum bonding pads. Chips may be mounted with conductive
epoxy or a gold-silicon preform.
72
(8)
BONDING PAD ASSIGNMENTS
(7)
(2)
94
IN
IN –
(1)
(3)
+
(2)
(8)
OFFSET N1
(6)
OFFSET N2
CHIP THICKNESS: 15 TYPICAL
BONDING PADS: 4 × 4 MINIMUM
TJmax = 150°C
TOLERANCES ARE ± 10%.
ALL DIMENSIONS ARE IN MILS.
(3)(1)
(4)
PIN (4) IS INTERNALLY CONNECTED
TO BACKSIDE OF CHIP.
V
CC+
(7)
+
–
V
CC–
(4)
(6)
OUT
2
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
schematic
OFFSET N1
OP07C, OP07D, OP07Y
PRECISION OPERATIONAL AMPLIFIERS
SLOS099B – OCTOBER 1983 – REVISED AUGUST 1996
7
V
CC +
1
IN +
IN –
8
6
OUT
3
2
28
39
4
4
V
CC –
OFFSET N2
COMPONENT COUNT
Resistors
Transistors
Capacitors
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
Supply voltage, V
Supply voltage, V
Differential input voltage (see Note 2) ±30 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Input voltage, V
Duration of output short circuit (see Note 4) unlimited. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Continuous total dissipation at (or below) 25°C free-air temperature (see Note 5) 500 mW. . . . . . . . . . . . . . . .
Operating free-air temperature range, T
Storage temperature range –65°C to 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds 260°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTES: 1. All voltage values, unless otherwise noted, are with respect to the midpoint between V
2. Differential voltages are at IN+ with respect to IN–.
3. The magnitude of the input voltage must never exceed the magnitude of the supply voltage or 15 V, whichever is less.
4. The output may be shorted to ground or either power supply.
5. For operation above 64°C free-air temperature, derate the D package to 464 mW at 70°C at the rate of 5.8 mW/°C.
(see Note 1) 22 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CC+
–22 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CC–
(either input, see Note 3) ±22 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
I
0°C to 70°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A
CC+
and V
CC–
.
recommended operating conditions
Supply voltage, V
Common-mode input voltage, V
Operating free-air temperature, T
CC±
IC
A
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
MIN MAX UNIT
±3 ±18 V
V
= ±15 V –13 13 V
CC±
0 70 °C
3
Loading...