Teledyne T3AFG40, T3AFG120, T3AFG80 Quick Start Manual
T3AFG40 / T3AFG80 / T3AFG120
Function / Arbitrary Waveform Generators
Quick Start Guide
Version 1.1
September, 2018
Contents
General Safety Summary..........................................................................................1
Adjustment Handle....................................................................................................2
The Front Panel .................................................................................................... 3
Back Panel ............................................................................................................ 8
Touch Screen Display .......................................................................................... 10
Built-In Help System …......................................................................................... 12
© 2018 Teledyne LeCroy, Inc. All rights reserved.
Teledyne Test Tools is a brand and trademark of Teledyne LeCroy, Inc. Other
product or brand names are trademarks or requested trademarks of their respective
holders. Specifications, prices, availability and delivery subject to change without
notice.
Quick Start 1
General Safety Summary
Read the following precautions carefully to avoid any
personal
injuries,
or damage to the instrument or products connected to it.
Use the instrument only as specified.
Use only the power cord supplied for the instrument.
Ground the instrument. The instrument is grounded through the
ground conductor of the power cord. To avoid electric shock,
always connect to grounded outlets. Make sure the instrument is
grounded correctly before connecting its input or output terminals.
Do not connect external signals. The BNC connector is used to
output the generated waveforms only. No external signals should
be connected to the BNC, or the instrument may be damaged.
Observe all terminal ratings and signs on the instrument to
avoid fire or electric shock. Before connecting to the instrument,
read the manual to understand the input/output ratings.
Do not operate with suspected failures. If you suspect that the
instrument is damaged, contact the Teledyne LeCroy service
department immediately.
Do not operate in wet/damp conditions.
Do not operate in an explosive atmosphere.
Keep the surface of the instrument clean and dry.
Avoid touching exposed circuits or wires. Do not touch
exposed contacts or components when the power is on.
Do not operate without covers. Do not operate the instrument
with covers or panels removed.
Use only the fuse specified for the instrument.
Use proper overvoltage protection.
Observe ventilation requirements. Ensure good ventilation.
Check the vent and fan regularly to prevent overheating.
2 Quick Start
Safety Terms and Symbols
The following terms may appear on the instrument:
DANGER:
Direct injury or hazard may occur.
WARNING:
Potential injury or hazard may occur.
CAUTION:
Potential damage to instrument/property may occur.
The following symbols may appear on the instrument:
CAUTION
Risk of
injury or
damage.
Refer to
manual.
WARNING
Risk of
electric
shock or
burn
Earth
Ground
Terminal
Protective
Conductor
Terminal
Frame or
Chassis
Terminal
ON/
Standby
Power
Alternating
Current
Operating Environment
Temperature: 0 °C to 40 °C
Relative Humidity: 5 to 90% RH at ≤ 30 °C
Altitude: ≤ 3048 m at ≤ 30 °C
Use indoors only.
Pollution degree 2. Use in an operating environment where
normally only dry, non-conductive pollution occurs. Temporary
conductivity caused by condensation should be expected.
AC Power
Input Voltage & Frequency: 100-120 V at 400 Hz or
100-240 V at 50/60 Hz
Automatic AC selection.
Power Consumption: 50 W maximum
Mains Supply Connector: CAT II per IEC/EN 61010-1:2010,
instrument intended to be supplied from the building wiring at
utilization points (socket outlets and similar).
Handle Adjustment
Users can adjust the handle to the required position by pulling
the mounting points outward and adjusting the handle position.
Handle Adjustment
Horizontal Position
Carrying Position
Quick Start 3
Fuse Type
1.25 A, 250 V
Loading...