Teledyne T3AFG5, T3AFG10 Quick Start Manual

Version 1.1

September, 2018

T3AFG5 / T3AFG10

Function / Arbitrary Waveform Generators

Quick Start Guide

Contents

General Safety Summary................................................................................. 1

Adjustment Handle ........................................................................................... 4

Front Panel ...................................................................................................... 5

Back Panel ........................................................................................................ 9

User Interface.................................................................................................. 10

Using In-line Help System ................................................................................12

© 2018 Teledyne LeCroy, Inc. All rights reserved.

Teledyne Test Tools is a brand and trademark of Teledyne LeCroy, Inc. Other
product or brand names are trademarks or requested trademarks of their
respective holders. Specifications, prices, availability and delivery subject to
change without notice.

General Safety Summary

Read the following precautions carefully to avoid any
injuries,
Use the instrument only as specified.

Use only the power cord supplied for the instrument.

Ground the instrument. The instrument is grounded through the
ground conductor of the power cord. To avoid electric shock,
always connect to grounded outlets. Make sure the instrument is
grounded correctly before connecting its input or output terminals.

Do not connect external signals. The BNC connector is used to
output the generated waveforms only. No external signals should
be connected to the BNC, or the instrument may be damaged.

Observe all terminal ratings and signs on the instrument to
avoid fire or electric shock. Before connecting to the instrument,
read the manual to understand the input/output ratings.

Do not operate with suspected failures. If you suspect that the
instrument is damaged, contact the Teledyne LeCroy service
department immediately.

or damage to the instrument or products connected to it.

personal

Do not operate in wet/damp conditions.

Do not operate in an explosive atmosphere.

Keep the surface of the instrument clean and dry.

Avoid touching exposed circuits or wires. Do not touch

exposed contacts or components when the power is on.

Do not operate without covers. Do not operate the instrument
with covers or panels removed.

Use only the fuse specified for the instrument.

Use proper over voltage protection.

Observe ventilation requirements. Ensure good ventilation.

Check the vent and fan regularly to prevent overheating.

Quick Start 1

2 Quick Start

Safety Terms and Symbols

The following terms may appear on the instrument:

DANGER:

Direct injury or hazard may occur.

WARNING:

Potential injury or hazard may occur.

CAUTION:

Potential damage to instrument/property may occur.

The following symbols may appear on the instrument:

CAUTION

Risk of

injury or

damage.

Refer to

manual.

WARNING

Risk of
electric

shock or

burn

Earth

Ground

Terminal

Protective

Conductor

Terminal

Frame or

Chassis

Terminal

ON/

Standby

Power

Alternating

Current

Operating Environment

Temperature: 0 °C to 40 °C

Relative Humidity: 90% RH at ≤ 35 °C, 60% RH at 35 - 40 °C

Altitude: ≤ 3000 m

Use indoors only.

Pollution Degree 2. Use in an operating environment where

normally only dry, non-conductive pollution occurs. Temporary
conductivity caused by condensation should be expected.

Quick Start 3

AC Power

Input Voltage & Frequency: 100-120 V at 400 Hz or

100-240 V at 50/60 Hz

Automatic AC selection.

Power Consumption: 50 W maximum

Mains Supply Connector: CAT II per IEC/EN 61010-1:2010,

instrument intended to be supplied from the building wiring at
utilization points (socket outlets and similar).

Fuse Type

1.25 A, 250 V