Teledyne 6400E User Manual
Specifications and Main Features
- Model Number: 6400E
- Kind of Device: SO2 Analyzer
- Measuring Range: 50 ppb to 20000 ppb, Dual range or Auto Range
- Measuring Units: ppb, ppm, μg/m³, mg/m³ (user selectable)
- Noise at Zero: 0.2 ppb RMS
- Noise at Span: 0.2 ppb RMS
- Limit of Detection: 0.4 ppb RMS
- Zero Drift 24 hours: <0.5 ppb
- Zero Drift 7 days: 1 ppb
- Span Drift 7 Days: <0.5% FS
- Calibration Curve: 1% of full scale
- Accuracy: 0.5% of reading
- Temperature Coefficient: < 0.1% per °C
- Voltage Coefficient: < 0.05% per V
- Response Time: 20 sec
- Time Constant: <100 sec for 95% response
- Sample Flow: 650 cc/min ± 10%
- Working Temperature: 5 – 40 degrees
- Working Humidity: 0 - 95 % RH Non Condensing
- Size: : 7in x 17in x 23.5in (178mm x 432mm x 597mm)
- Mass: 45 lb (20.5 kg) With internal pump
- Electrical Input: 100 V, 50/60hz (3.25A); 115 V, 60hz (3.0 A); 220-240V, 50/60hz (2.5 A)
- Environmental classification: II; Pollution degree 2
- Indicators Output: 8 indicators output from the use of opto isolators
- Serial Communication Peripheral: One RS-232 Serial Computer Connection Port and One RS-485 (2 ports in parallel)
- Speed or Baud Rate: In the range of 300 upto 115200; Ethernet interface is optional
Over certain convenience: EN61326; FCC Part 15; ICES-003 Class A; IEC 61010-1
Frequently Asked Questions
Q: What is the temperature working range of 6400E analyzer?
A: 5 degrees to 40 degrees interpret in celsius is the working range
Q: Which measurement units are offered in the 6400E?
A: Ppb, ppm, µg/m³ and mg/m³ are the offered measurement units
Q: What is the approximate In-out time duration after given 60 minutes to the 6400 E-analyzer to start with its reliable purpose?
A: it needs approximately 1 hour or 60 minutes in which it can warm itself up
Q: In a situation when there are warning messages shown after allowing it over 60 min warming are there any solutions?
A: There are set guidelines to the issues and how to resolve them in Chapter 11 of the manual so one has to follow them
Q: What is rate of flow of the sample in the Model 6400E?
A: Rate of 650 ccm/min with an allowance of 10% in the defined rate.
Model 6400E’s warranty is structured as follows, Answers How It Is Covered or Teledyne Analytical Instruments.
User Manual
Loading...