Teac PBT700 TWIST User Manual

TWIST

PBT700 Bluetooth Speaker

What’s in the box

1 x PBT700 Bluetooth speaker
1 x Mini USB charge cable
1 x Users manual
1 x AUX cable

Layout of operating buttons/connectors

Bluetooth Connecting button | Power/Mode – with Pairing LED indicator built-in

Volume +/- | Answer-phone-call/Play/Pause | Microphone

ON/OFF sliding switch | mini USB charging port | AUX-in

LED charging indicator

OFF – fully charged

RED – charging
Blink – lower battery power

Charging the PBT700 (3.7V rechargeable battery built-in)

1- Turn off PBT700 before charging
2- Connect PBT700 using the supplied USB cable to a power source such as PC or USB

charging devices (not included)

3- Red indicator light is ON during charging, turns OFF after fully charged.
4- Red indicator blinks to remind low battery power, it is time for charging.

Switch ON/OFF the PBT700

1- After fully charged, turn ON/OFF sliding switch (on back side of the unit) to “ON”
2- Switch-on: Long press Power/Mode button until Red LED appears, then release it, red & blue

LED blinks quickly, PBT700 is in standby-mode for pairing.
3- Switch-off: again Long press Power/Mode button until RED LED appears, then release it, red

LED disappears after switch-off.
4- Turn ON/OFF sliding switch to “OFF”

Note: If long press Power/Mode to switch off before turn ON/OFF sliding switch to “OFF”, PBT700
will remember paired device and pair automatically next time.
If turn ON/OFF sliding switch to “OFF” directly without long press Power/Mode button,
PBT700 will not remember paired devices.