TASCAM CD Duplicator systems are high-precision electronic devices. Do not use them
in any manner other than as specified in this manual. Please read this manual in its entirety
before you begin the installation procedure. Use of controls, adjustments, or performance
of procedures other than those specified herein may result in hazardous radiation exposure.
To prevent fire or shock, do not expose the unit to moisture or rain.
To prevent electrical shock, do not attempt to disassemble the CD Duplicator system. Refer
servicing to authorized personnel.
TASCAM CD Duplicator drives utilize a laser beam that can be harmful to your eyes. Do
not disassemble the cabinet or unit. Do not attempt to look through the front panel or into
the unit while the power is turned on.
A user who changes or modifies the unit or operating procedures specified herein without
expressed written approval by the manufacturer will void user authority to operate the
equipment.
Specifications and features subject to change without notice or obligation.
FCC Radio Frequency Interference Regulations
Warning:
not installed and used in accordance with the instructions contained in this manual, may
cause harmful interference to radio and television communications. This equipment has
been tested and found to comply with the limits for a Class B digital device pursuant to
Subpart J of Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. However, there is no
guarantee that interference will not occur in a particular installation. To ensure compliance
with FCC rules, the cable that connects the unit to the computer must be a shielded interface
cable.
Note:
requirements or using an unshielded peripheral cable could result in interference to radio
or television reception. To ensure that the use of this product does not contribute to
interference, use a shielded interface cable.
If this equipment does cause harmful interference to radio or television reception (which
can be determined by turning the equipment off and on), the user may try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Move the device and the receiver further apart.
• Connect the equipment to an electrical outlet on a different circuit than the receiver.
• Consult the dealer or an experienced audio television technician.
Also, the following booklet may prove helpful:
Interference Problems
Washington, D.C. 20402, stock number 004-000-00345-4.
The user is cautioned that any changes or modifications not expressly approved by TEAC
America, Inc. could void the user’s warranty.
This equipment generates, uses, and can radiate radio frequency energy and if
Connecting this device to peripheral devices that do not comply with Class B
How to Identify and Resolve Radio-TV
. It is available from the U.S. Government Printing Office,
TEAC America, Inc. reserves the right to modify product offerings or specifications
without advanced notice. No part of this publication may be reproduced in any format
without the expressed written permission of TEAC America, Inc.
TASCAM and TEAC are registered trademarks of TEAC Corporation. All other
trademarks and registered trademarks are the property of their respective owners.
Piracy Statement
The copying of audio, video, or software without the permission of the copyright holder is
illegal. TEAC accepts no responsibility for copyright infringement or misuse of this
equipment. It is the sole responsibility of the user to ensure that the legal copyrights of the
copyright owners are respected.
About This Manual
This
TASCAM Tower CD Duplicator User’s Manual
TASCAM Tower CD Duplicator. It is divided into the following chapters:
Chapter 1: Introduction
This chapter describes the shipping package contents and introduces the TASCAM Tower
CD Duplicator.
Chapter 2: Using the CD Duplicator
This chapter explains how to set up the CD Duplicator. It also details its basic copy
operation.
Chapter 3: CD Duplicator Functions
This chapter explains all available functions of the CD Duplicator.
Appendix A: List of Functions
Appendix A includes a complete list of all CD Duplicator functions.
Appendix B: LCD Messages
Appendix B lists all messages that may appear on the LCD display.
Appendix C: About CD-R and CD-RW Discs
Appendix C contains information about handling, loading, and ejecting discs.
Appendix D: Specifications
Appendix D includes technical specifications for the TASCAM Tower CD Duplicator
units.
Appendix E: Technical Support and Warranty
This appendix explains how to contact technical support at TASCAM and provides Limited
Warranty information.
Thank you for purchasing a TASCAM Tower CD Duplicator.
Note:
This User's Manual is intended for both the CD-D13 1x3 and CD-D17HD
1x7 Tower CD Duplicator systems. Operational instructions for both models are
essentially the same. The primary difference between models is the number of
target drives and the inclusion of a hard disk drive. Other minor differences
between the models are described herein as necessary.
The TASCAM Tower CD Duplicator is a stand-alone disc-to-disc CD Duplicator
system that does not require connection to a computer. It can duplicate a single
master CD to CD-R media at up to 52X speeds, resulting in an exact replica of a
700MB disc. It can also duplicate discs to CD-RW media at up to 32X speeds.
The TASCAM Tower CD Duplicator is designed to perform CD copying quickly
and accurately. The CD Duplicator automatically identifies source CD formats
and replicates the content as required.
The TASCAM Tower CD Duplicator performs continuous copying with no
waiting. It is an ideal CD duplicator for the advanced user who requires speed and
accuracy.
You can set up your TASCAM Tower CD Duplicator very quickly and easily.
There is no need to install any software. There is no need to attach any cables to
your computer. The TASCAM Tower CD Duplicator functions entirely as a
stand-alone unit.
Caution:
or 220VAC voltage. Before you turn on the power to the unit, be certain to select
the correct voltage for your region by setting the AC Voltage Selector on the rear
panel. Failure to do so can result in damage to the unit. For more information,
refer page 5.
TASCAM Tower CD Duplicator User’s Manual1
Your TASCAM Tower CD Duplicator can operate on either 115VAC
CD Duplicator Package Contents
CD Duplicator Package Contents
Your TASCAM CD Duplicator package includes the following items (see
Figure 1).
❑
TASCAM (1x3 or 1x7) Tower CD Duplicator unit
❑
AC power cable
❑
TASCAM Tower CD Duplicator User’s Manual
(this booklet)
User’s Manual
1x3 CD DuplicatorAC power cable
Figure 1. CD Duplicator Unit Package Contents
Note:
If any of the items above is missing from your package upon purchase,
OR
1x7 CD Duplicator
please contact your vendor immediately.
2TASCAM Tower CD Duplicator User’s Manual
Front Panel
Figure 2 illustrates the front panel of the Tower CD Duplicator unit.
source drive
target drive
LCD control panel
target drive
power switch
LED status indicators
Front Panel
Figure 2. Front Panel of the CD Duplicator Unit
source drive:
Insert the disc to be copied into the source drive. Use the disc
tray to load a CD into the drive. You can open the tray by pressing the eject
button (if the tray fails to open, you can use the emergency eject mechanism).
You can close the tray by pressing the eject button.
Notes:
❑
TASCAM strongly recommends that you do not push the tray in to close
it. Please press the eject button to eject or retract the tray.
❑
The Tower CD Duplicator may include an internal hard disk drive as
an alternate source drive. Please refer to “Specifications” on page 28
for detailed information on the model that you purchased.
TASCAM Tower CD Duplicator User’s Manual3
Front Panel
LCD control panel:
Use the control panel buttons to navigate through the
various functions viewed on the LCD display.
Figure 3. LCD Control Panel
The CD Duplicator control panel features an LCD display and four buttons.
These buttons are described in the following table:
Press the Up arrow button to scroll up functions or menus.
Press the Down arrow button to scroll down functions or menus.
Press the ENT (Enter) button to execute a selected function.
Press the ESC (Escape) button to cancel a selected function or to return to
the main menu.
target drives:
Insert a blank disc into each target drive to make a copy of the
source disc. You can open the tray by pressing the eject button (if the tray fails
to open, you can use the emergency eject mechanism). You can close the tray
by pressing the eject button.
Note:
TASCAM strongly recommends that you do not push the tray in to
close it. Please press the eject button to eject or retract the tray.
power switch:
Use the power switch to turn the power to the CD Duplicator
unit on and off.
LED power indicator:
when the CD Duplicator power is on
4TASCAM Tower CD Duplicator User’s Manual
The LED power indicator will be continuously lit
.
Loading...
+ 26 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.