TM
Tactic’s 5.8GHz First Person View Wrist Monitor with integrated receiver is
intended for receiving video signals from a 5.8GHz FPV transmitter (available
separately) when mounted inside an R/C hobby model. Four bands with a total
of 32 frequencies in the 5.8GHz spectrum are available. For optimum results,
operate the system away from other 5.8GHz transmitters and in areas having
as few obstructions as possible between you and the Tx.
FPV-RM1
CONTENTS
(1) 5.8GHz FPV Wrist 2 inch Color Monitor with 32 Channels
(1) Micro USB Cable
(1) Instruction manual
It is strongly recommended to read this manual completely
before use! Damage resulting from misuse or modi cation will
void your warranty.
INPUT POWER OPTIONS
CHARGING THE BATTERY: This monitor includes a built-in circuit to recharge
the internal lithium polymer battery. Connecting an external 5V DC power source
to the monitor’s Micro USB jack will automatically start the charge process, as
indicated by the glowing red LED on the bottom edge of the watch. The LED will
turn off when charge is complete. Acceptable power sources include a computer
USB port or an AC USB adapter commonly used for cell phones. Item number
DIDP1125 Dromida AC USB Charger Adapter 2 Amp is also available through
local hobby retailers.
WARNING! Charging lithium-polymer batteries poses a risk of FIRE! Follow
all care and handling instructions in this manual to avoid quick,
severe, permanent damage to the batteries and all surroundings
which could result from improper use and function.
■ Never attempt to charge the monitor while it is being worn. Always
remove the watch to charge the battery.
■ Do not connect an external battery charger to the monitor’s micro
USB in jack.
■ Do not leave the monitor unattended while being charged!
■ Immediately disconnect the DC power source if the battery becomes hot (over
140°F, 60°C), begins to swell or emits smoke. Wear re protective materials
on your hands to move the monitor to a reproof location as it may be hot!
Leave the monitor until it cools.
■ Always charge the monitor in a reproof location. Monitor the area with a
smoke alarm, and have a lithium approved re extinguisher available at all times.
■ Always provide adequate ventilation around the monitor during charge.
■ Always keep LiPo batteries away from children.
■ Do not allow the internal electrolyte from LiPo, Li-Ion or LiFe batteries to
get in the eyes or on skin – wash affected areas immediately if they come in
contact with the electrolyte and contact your physician!
■ Do not place the charger or monitor on ammable surfaces or near combustible
materials (carpet, paper, wood, plastic, vinyl, foam, etc.) while charging.
The 5.8GHz FPV Wrist 2 inch Color Monitor has a built in antenna which stores
ANTENNA OPERATION
The FPV wrist monitor has a built-in antenna which stores in the left side of the
watch when not being used. Gently slide the antenna out until it stops. Then
ip the antenna up for maximum range. When not viewing FPV video, gently
slide the antenna back into the side of watch to prevent breakage.
SCREEN & CONTROLS
POWER: Press and hold the power button for 3 seconds to turn the
monitor on or off.
Press the “CH” button quickly to scroll through the channels. The LED bar on
the bottom edge of watch will display the channel.
Press and hold
the “CH” button to
scroll through the
bands. The LED
bar on the bottom
edge of the watch
will display the
band.
BAND A
BAND B
BAND E
BAND F
CH1
5865
5733
5705
5740
CH2
5845
5752
5685
5760
CH3
5825
5771
5665
5780
CH4
5805
5790
5645
5800
Frequency in MHz
CH5
5785
5809
5885
5820
CH6
5765
5828
5905
5840
CH7
5745
5847
5925
5860
CH8
5725
5866
5945
5880
Loading...