Symbol Technologies LMX5452 User Manual

The Enterprise Mobility Company

FCC ID: H9PLMX5452

H9PLMX5452

End product User Guide Information

The Symbol Technologies Inc. Bluetooth Module with Symbol Model number LMX5452 is a module intended for integration into Symbol Products only, as such it have no User Manual.

The end user will be instructed to include the following information to the end product User Guide:

1.Regulatory Information

All Symbol devices are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required.

Any changes or modifications to Symbol Technologies equipment, not expressly approved by Symbol Technologies, could void the user’s authority to operate the equipment.

Radio Modules

The device contain approved radio module(s) as identified below: Symbol Bluetooth Module, Model: LMX5452

Products equipped with Bluetooth® Wireless Technology

This is an approved Bluetooth product. BT ID: Bxxxxx

2.Country Approvals

Regulatory markings are applied to the device signifying the radio (s) are approved for use in the following countries: United States, Canada, Australia, Japan and Europe 1,.

Please refer to the Symbol Declaration of Conformity (DoC) for details of other country markings. This is available at http://www2.symbol.com/doc/.

Note 1: For 2.4GHz Products: Europe includes, Austria, Belgium, Czech Republic, Croatia, Cyprus, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovak Republic, Slovenia, Spain, Sweden, Switzerland and the United Kingdom.

Operation of the device without regulatory approval is illegal.

FCC ID: H9PLMX5452

IC: 1549D-LMX5452

The Enterprise Mobility Company

FCC ID: H9PLMX5452

Warnings for Use of Wireless Devices

Please observe all warning notices with regard to the usage of wireless devices.

RF Exposure Guidelines

Safety Information

The device complies with Internationally recognised standards covering Specific Absorption Rate (SAR) related to human exposure to electromagnetic fields from radio devices.

Reducing RF Exposure – Use Properly

It is advisable to use the device only in the normal operating position.

Handheld Devices

This device was tested for typical body-worn operation. Use only Symbol tested and approved beltclips, holsters, and similar accessories to ensure FCC Compliance. The use of third-party belt-clips, holsters, and similar accessories may not comply with FCC RF exposure compliance requirements, and should be avoided.

Remote and Standalone Antenna Configurations.

To comply with FCC RF exposure requirements, antennas that are mounted externally at remote locations or operating near users at stand-alone desktop of similar configurations must operate with a minimum separation distance of 20 cm from all persons.

Radio Frequency Interference Requirements-FCC

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

FCC ID: H9PLMX5452

IC: 1549D-LMX5452