Sunbeam FPSBCP941 User Manual

TM

TM

For product questions:

Sunbeam Consumer Service

USA: 1.800.458.8407

www.sunbeam.com

©2011 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions.

All rights reserved. Distributed by Sunbeam Products, Inc.

doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.

Para preguntas sobre los productos llame:

Sunbeam Consumer Service

EE.UU.: 1.800.458.8407

www.sunbeam.com

User Manual Electric Cookie Press

Manual de Instrucciones Prensa Eléctrica para Galletas

©2011 Sunbeam Products, Inc. operando bajo el nombre

de Jarden Consumer Solutions.

Todos los derechos reservados. Distribuido por Sunbeam Products, Inc.

operando bajo el nombre de Jarden Consumer Solutions,

Boca Raton, Florida 33431.

Printed in China Impreso en China
FPSBCP941_11ESM1 GCDS-SUN22649-JC

FPSBCP941_11ESM1.indd 1-1 8/15/11 9:19 AM

www.sunbeam.com

P.N. 152998

IMPORTANT SAFEGUARDS

THIS UNIT IS INTENDED FOR

When using an electrical appliance basic safely precautions should always be
followed including the following:

1. Read carefully and save all the instructions provided with an appliance.
This appliance is not a toy.

2. Do not touch moving parts. Never feed dough by hand.

3. To protect against electric shock do not immerse cord, plugs or any part in
question in water or any other liquid.

4. Always attach plug to appliance first, then plug cord in the wall outlet.
To disconnect, turn off any control to “off”, then remove plug from wall
outlet.

5. Always plug your appliance cord into a power outlet of the voltage
(A.C. only) marked on the appliance.

6. Unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts, and before cleaning the appliance.

7. Close supervision is necessary when your appliance is being used near
children. Children should not use the appliance.

8. Never leave an appliance unattended while in use.

9. Do not use an appliance for any purpose other than its intended use.

10. Do not place an appliance on or near a hot gas flame, electric element
or on a heated oven. Do not place on top of any other appliance.

11. Do not let the power cord of an appliance hang over the edge of a table
or bench top or touch any hot surface including the stove.

12. Do not operate any electrical appliance with a damaged cord or after
the appliance has been damaged in any manner. If damage is suspected,
return the appliance to the nearest Sunbeam Appointed Service Center
for examination, repair or adjustment.

13. The use of accessory attachments not recommended by the appliance
manufacturer may cause injuries and should not be used.

14. Do not use outdoors.

15. Appliances are not intended to be operated by means of an external timer
or separate remote control system.

16. This appliance is intended for household use only.

17. Do not place any part of this appliance in a dishwasher.

HOUSEHOLD USE ONLY.

This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, as a safety feature, this plug is intended to
fit into a polarized outlet only one way. If the plug does not fit fully into the
outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not attempt to modify the plug in any way.

EXTENSION CORD USE

A short power-supply cord (or detachable power-supply cord) is provided to
reduce the risk resulting from becoming entangled in or tripping over a longer
cord. Longer detachable power-supply cords or extension cords are available
and may be used if care is exercised in their use.

If a long detachable power-supply cord or extension cord is used, the electrical
rating of the cord or extension cord must be at least as great as the electrical
rating of the appliance. The extension cord should be arranged so that it
will not drape over the countertop or tabletop where it can be pulled on by
children or tripped over unintentionally.

SAVE THESE INSTRUCTIONS

If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com or contact the Sunbeam Consumer Service
Line. Ensure the above safety precautions are understood.

-2- -3-

FPSBCP941_11ESM1.indd 2-3 8/15/11 9:19 AM

Learning about Your

Cookie Press

How to assembLe

How to make Cookies

A

B

C

D

It is recommended to wash all of the cookie press parts except the BODY (C)
with warm, soapy water before first use. Dry these parts thoroughly before use.

NOTE: Don’t immerse the BODY (C), CORD (A) and PLUG in any liquid.

1. Turn Cam Disc (D) counter-clockwise until it clicks.

2. By inserting the stem of Cam Shaft (E) into the center hole of the Cam Disc
(D), the Cam Shaft (E) attaches to the Cam Disc (D). By turning clockwise
it will click when it is properly aligned.

3. Select a Cookie Disc (K) and place it into Tube Cover (J).

4. Next, by turning clockwise place Tube Cover (J) into bottom part of the
Tube (F).

5. When using a Pastry Tip (H), fit it over the Pastry Tip Adapter (G) and
secure it with the Tip Cover (I).

6. The pastry tip assembly then goes inside the tube cover (J).

7. Load the prepared cookie dough or filling. NEVER FILL THE TUBE (F)

E

MORE THAN THE MAX FILL LINE.

8. Furthermore, the ridges on the inside of the Tube (F) need to be aligned
with the outside contours of the assembled discs (D). Align the arrows of
the Tube (F) with the Motor Body (C). Make sure top arrow on Tube (F)
lines up and is in the lock position.

1. The consistency of the cookie dough is very important when making
cookies with your SunbeamTM cookie press. When the cookie dough is too

F

G

K

J

A. Power Cord (Plug

NOT shown)
B. On/Off Button
C. Motor Body
D. Cam Disc
E. Cam Shaft

F. Tube
G. Pastry Tip Adapter
H. Pastry Tip(s)
I. Pastry Tip Cover
J. Tube Cover
K. Cookie Disc(s)

-4- -5-

H

I

soft, refrigerate it for about 10-15 minutes. On the other hand, when the
dough is too stiff it will not release from the appliance.

TIP: The use of store-bought cookie dough is not recommended.

2. Insert the plug into a 120 volt power outlet when filled with cookie dough.

3. With the cookie press upright press against the surface of the cookie sheet.

4. Press the On/Off button (B) until the air pockets are removed from the tube.

5. Press a cookie for about 2 seconds. Based on the desired thickness and
shape of the cookie the pressing times will vary.

6. When done, release the On/Off button (B) and repeat to the next position
on the cookie sheet.

TIP: When the dough is loaded in the cookie press, use it immediately.

7. When refilling the cookie press with dough, always UNPLUG the unit first.

NOTE: When different type of cookie dough needs to be used, clean the

cookie press before refilling. NEVER IMMERSE THE MOTOR BODY (C)
IN WATER OR ANY OTHER LIQUID.

FPSBCP941_11ESM1.indd 4-5 8/15/11 9:19 AM