Structural Concepts DTS36 Installation Manual

READ AND SAVE THESE INSTRUCTIONS

INSTALLATION AND

OPERATING MANUAL

SERVICE-AMBIENT TABLE SPHERICAL

GLASS OUTSIDE WEDGE MERCHANDISERS

Model DTSOW45

PN 54075

SERVICE-AMBIENT TABLE SPHERICAL

GLASS INSIDE WEDGE MERCHANDISERS

Model DTSIW45

Model DTSOW90

Model DTS36 38 3/4”L* x 44 1/2”D x 54”H~
Model DTS48 50 3/4”L* x 44 1/2”D x 54”H~
Model DTS60 62 1/2”L* x 44 1/2”D x 54”H~
Model DTSOW45 41-1/4”L* x 45 3/8”D x 54”H~
Model DTSOW90 88 3/4”L* x 47 1/4”D x 54”H~
Model DTSIW45 14 1/2”L* x 54 1/2”D x 54 1/8”H~
Model DTSIW90 24 1/4”L* x 54 1/2”D x 54 1/8”H~

*Includes End Panels
~ With Adjustable Levelers Extended
1 1/2” Below Base Frame

888 E. Porter Road · Muskegon, MI 49441 Phone: [phone] Fax: [phone] www.structuralconcepts.com

I:\Oper Manuals\Encore\DTS_DTSOW_DTSIW_54075.pub

1

Model DTSIW90

SERVICE-AMBIENT TABLE

SPHERICAL GLASS MERCHANDISERS

Model DTS60

Rev. D Date: 7.2.2009

TABLE OF CONTENTS

OVERVIEW AND WARNINGS …….………………..…………………..…….……………......…..

INSTALLATION ………………………………………...……………………………………...……..
ADJOINING CASES ………………………………………………………………...………….…….
SHELF OPTION ……………..………………..………………………………………………………
TROUBLESHOOTING …………….……………………………………………….……….…….….

CLEANING SCHEDULE .…………………………………………………...…………………....….

TECHNICAL SERVICE CONTACT INFORMATION & WARRANTY INFORMATION ...….....

3
4
5
6
7
8
9

2

OVERVIEW AND WARNINGS

OVERVIEW

• This Structural Concepts® Encore® Service Non-Refrigerated case is designed to merchandise

packaged / unpackaged bakery products at ambient temperatures.

• This case should be installed and operated according to this Installation-Operating Manual to

insure proper performance.

• This unit is designed for the display of products in ambient store conditions where temperatures

and humidity are maintained at a maximum of 75°F / 24°C and 55% relative humidity.

This merchandiser is designed for the display of non-hazardous, packaged / unpackaged bakery
products (per NSF Std. 2 – 1999).

3

INSTALLATION

1. Remove Unit From Skid

• Remove case from skid and place into

proper position.

• To prevent damage, support case while

sliding skid out from under case.

• See illustration.

Carefully Slide Skid
Out From Under Unit

2. Position & Align Case Alongside
Other Cases

• Before adjusting levelers, make certain that

the case is in proper position and aligned
with adjoining case(s).

• This may require the repositioning of the

case you are installing or
positioned case(s).

3. Adjust Levelers

• After case is in proper position, adjust case

so it is level and plumb (see illustration at
right).

• You may need to remove front and/or rear

Toe-Kick to access levelers.

• Use adjustable wrench to adjust leveler.

• Depending upon case weight it may be

necessary to use a Pry Bar to accomplish
this task.

• Do not use Pry Bar on Toe-Kick as it may

buckle.

• Do not use Pry Bar on End Panel as it may

chip.

• Use Pry Bar ONLY on Base Frame to avoid

damaging case.

• See illustration and photos at right.

the already

Pry Bar

Block

Leveler

Support

case while

removing

from skid.

Adjustable

Wrench

Base

Frame

Toe-Kick

4

CASE ADJOINMENT

Case Adjoinment

• Case is shipped with end panel removed where it is to be adjoined.

• For proper case adjoinment, use the SCC®-provided 1/4-20 x 2 1/2” nuts, bolts and washers.

• Adjoinment is to be at locations ballooned below.

• SCC® Model shown below is for illustrative purposes. Your model’s appearance may slightly vary.

6

5

4

1

2

3

5

CASE ADJOINMENT SHELF OPTION

LED light removal / replacement:

• Contact Structural Concepts’ Technical

Service Department at 1.800.433.9489 for
replacement parts.

• Plug is to connect to LED light at raceway

side of case.

• To remove LED light fixture, disconnect

existing LED light from its brackets &
self-adhesive tape.

• Then, firmly grasp LED light while applying

outward pressure to brackets.

• Twist LED away from bracket to release.

• See illustrations at top and mid-right.

Plug and cord positioning:

• Plug is to connect to LED light at raceway

side of case.

• Before attaching LED light to case, plug

must connect to LED properly without cord
doubling-back.

• See photos of proper vs. improper

connections at below right.

Proper plug insertion into LED light
socket:

• Plug must be inserted into LED light

properly or the LED will not light up.

@ Important! The plug’s oval form
MUST be inserted into LED’s oval
form. The plug’s flat form must be
inserted into the LED’s flat form.

• See illustration at mid-right.

Shelf with

LED lights

Bracket

Plug’s Oval

Form

LED’s

Oval Form

Outward pressure to be applied

to bracket to remove LED light

Light Switch Located on

bottom side of rear wire way.

Proper plug connection into LED socket.

Improper plug connection into LED socket.

Note how cord is doubled-back.

6

TROUBLESHOOTING

Case Not Properly Lining Up

See Installation Section for instructions on properly aligning
case (alongside other cases) and adjusting levelers.

7

CLEANING SCHEDULE - TO BE PERFORMED BY STORE PERSONNEL

AREA TO BE CLEANED FREQUENCY INSTRUCTIONS

Case Exterior Daily

Daily

Quarterly

Case Interior Daily

Weekly

Glass: Clean outside front and side glass with a

household or commercial glass cleaner and a soft
cloth or paper towel.

End Panels, Front Panel, Toe-Kick, etc.: Wipe off
all surfaces with warm water and mild soap solution
and non-abrasive cloth.

Under Case: Remove front toe-kick (4 screws must
be removed). Vacuum under case to remove dust
and dirt that may collect under the case.

Glass: Clean inside front and side glass with a
household or commercial glass cleaner and a soft
cloth or paper towel.

Decks: Wipe off decks with moist cloth.

8

TECHNICAL SERVICE CONTACT INFORMATION & WARRANTY INFORMATION

STRUCTURAL CONCEPTS CORPORATION TECHNICAL SERVICE

PHONE NUMBER: 1.800.433.9489 or For Your Master Service Agent See

WWW.STRUCTURALCONCEPTS.COM/Contact/Master_Service_Agents.asp

WARRANTY INFORMATION

(Note: Standard Limited Warranty can be found at www.Struct ural conc ept s.com)

All sales by Structural Concepts Corporation (SCC) are subject to the following limited warranty. “Goods” refers to the product or products being sold by SCC.

Warranty Scope: Warranty is for equipment sold in the United States, Canada, Mexico and Puerto Rico. Limited warranty may apply to equipment sold elsewhere.
Warranty; Remedies; Limitations. SCC warrants that if any Goods are found by an authorized representative of SCC not to be of good material or workmanship within one

year of the date of shipments SCC will, at its option after inspection by an authorized representative, replace any defective Good or pay the reasonable cost of replacement
for any such defective Goods, provided that written notice of the defect is given to SCC within 30 days of the appearance of such defect. If notice is not given within such
period, any claim for breach of warranty shall be conclusively deemed to have been waived and SCC shall not be liable under this warranty. If SCC is unable to repair or
replace the defective Goods, SCC shall issue a credit to the Purchaser for all or part of the purchase price, as SCC shall determine. The replacement or payment in the
manner described above shall be the sole and exclusive remedy of Purchaser for a breach of this warranty. If any Goods are defective or fail to conform to this warranty,
SCC will furnish instructions for their disposition. No Goods shall be returned to SCC without its prior consent.

SCC’s liability for any defect in the Goods shall not exceed the purchase price of the Goods. SCC SHALL HAVE NO LIABILITY TO PURCHASE FOR CONSEQUENTIAL
DAMAGES OF ANY KIND WHATSOEVER, INCLUDING, BUT NOT LIMITED TO, PERSONAL INJURY, PROPERTY DAMAGE, LOST PROFITS, OR OTHER ECONOMIC
INJURY DUE TO ANY DEFECT IN THE GOODS OR ANY BREACH OF SCC, SCC SHALL NOT BE LIABLE TO THE PURCHASER IN TORT FOR ANY NEGLIGENT DE­SIGN OR MANUFACTURE OF THE GOODS, OR FOR THE OMISSION OF ANY WARNING THEREFROM.

SCC shall have no obligation or liability under this warranty for claims arising from any other party’s (including Purchaser’s) negligence or misuse of the Goods or
environmental conditions. This warranty does not apply to any claim or damage arising for or cause by improper storage, handling, installation, maintenance, or from fire,
flood, accidents, structural defects, building settlement or movement, acts of God, or other causes beyond SCC’s control.

Except as expressly stated herein, SCC makes no warranty, express, implied, statutory or otherwise as to any parts or goods not manufactured by SCC. SCC shall warrant
such parts or Goods only (I) against such defects, (II) for such periods of time, and (III) with such remedies, as are expressly warranted by the manufacturer of such parts of
Goods. Notwithstanding the foregoing, any warranty with respect to such parts of Goods and any remedies available as a result of a breach thereof shall be subject to all of
the procedures, limitations, and exclusions set forth herein.

THE WARRANTIES HEREIN ARE IN LIEU OF ALL WARRANTIES, EXPRESS, IMPLIED, STATUTORY, OR OTHERWISE. IN PARTICULAR, SCC MAKES NO
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

No representative, agent or dealer of SCC has authority to modify, expand, or extend this Warranty, to waive any of the limitations or exclusions, or to make any different or
additional warranties with respect to Goods.

Period of Limitations. No claim, suit or other proceeding may be brought by Purchaser for any breach of the foregoing warranty or this Agreement by SCC or in any way
arising out of this Agreement or relating to the Goods after one year from the date of the breach. In the interpretation of this limitation on action for a breach by SCC, it is
expressly agreed that there are no warranties of future performance of the goods that would extend that period of limitation herein contained for bringing an action.

Indemnifications. Purchaser agrees to indemnify, hold harmless, and defend SCC if so requested, from any and all liabilities, as defined herein, suffered, or incurred by SCC
as a result of, or in connection with, any act, omission, or use of the Goods by Purchaser, its employees or customers, or any breach of this Agreement by Purchaser.
Liabilities shall include all costs, claims, damages, judgments, and expenses (including reasonable attorney fees and costs).

Remedies of SCC. SCC’s rights and remedies shall be cumulative and may be exercised from time to time. In a proceeding or action relating to the breach of this Agreement
by Purchaser, Purchaser shall reimburse SCC for reasonable costs and attorney’s fees incurred by SCC. No waiver by SCC of any breach of Purchaser shall be effective
unless in writing nor operate as a waiver of any other breach of the same term thereafter. SCC shall not lose any right because it has not exercised it in the past.

Applicable Law. This Agreement is made in Michigan and shall be governed by and interpreted according to Michigan law. Any lawsuit arising out of this Agreement or the
Goods may be handled by a federal or state court whose district includes Muskegon County, Michigan, and Purchaser consents that such court shall have personal
jurisdiction over Purchaser.

Miscellaneous. If any provision of this Agreement is found to be invalid or unenforceable under any law, the provision shall be ineffective to that extent and for the duration of
the illegality, but the remaining provisions shall be unaffected. Purchaser shall not assign any of its rights nor delegate any of this obligations under this Agreement without
prior written of SCC. This Agreement shall be binding upon and inure to the benefit of SCC and Purchaser and each of their legal representatives, successors and assigns.

SCC warrants its products to be free of defects in materials and workmanship under normal use and service for a period of one (1) year from the date of delivery.
This warranty is extended only to the original purchaser for use of the Goods. It does not cover normal wear parts such as plastic tongs, tong holders, tong cables, bag

holders, or acrylic dividers.
General Conditions. All service labor and/or parts charges are subject to approval by SCC. Contact the Customer Service Department in writing or call 231-798-8888.
All claims must contain the following information: (1) model & serial code number of equipment; (2) the date and place of installation; (3) the name and address of the agency

which performed the installation; (4) the date of the equipment failure; and (5) a complete description of the equipment failure and all circumstances relating to that failure.
Once the claim has been determined to be a true warranty claim by SCC’s Customer Service Department, the following procedure will be taken: (1) replacement parts will be

sent at no charge from SCC on a freight prepaid basis; (2) reimbursement for service labor will be paid if the following conditions have been met— (a) prior approval of ser­vice agency was awarded from the Customer Service Department; and (b) an itemized statement of all labor charges incurred is received by the Customer Service Depart­ment. The cost of the service labor reimbursement will be based on straight time rates and reasonable time for the repair of the defect.

If problems occur with any compressor, notify SCC’s Customer Service Department immediately. Any attempt to repair or alter the unit without prior consent from the
Customer Service Department will render any warranty claim null and void. This warranty and protection plan does not apply to any condensing unit or any part thereof which
has been subject to accident, negligence, misuse, or abuse, or which has not been operated in accordance with the manufacturer’s recommendations or if the serial number
of the unit has been altered, defaced, or removed.

Limit of Liability. The limit of liability of SCC toward the exchange cost of the original condensing unit, F.O.B. SCC, Norton Shores, MI, of each motor-compressor assembly
replaced during the warranty shall not exceed manufacturer's current established wholesaler’s exchange price and in no case shall the labor of removing or replacing the
motor-compressor or parts thereof be the responsibility of SCC.

9