State GTS-320-NEH User Manual

R E S I D E N T I A L

GAS TANKLESS HIGH EFFICIENCY CONDENSING MODELS

FEATURES

Safety Features:

• Air-Fuel Ratio (AFR) Sensor

• Exhaust & Water Temperature Safety Control

• Overheat Cutoff Fuse

Internal Freeze Protection System

Power Direct Vent Design

• 4" Pipe Vents up to 50 Equivalent Feet or 3" Pipe Vents up to 25 Equivalent Feet

• Uses Inexpensive PVC, CPVC, or ABS Pipe for Venting (solid core only). Canadian Installations Require ULCS636 Listed PVC or CPVC Pipe for Venting.

• Category III Stainless Steel Venting can also be used

Accessories

• RemoteTemperature Controller

• Pipe Cover

• Neutralizer Kit

• Plumbing Installation Kits

• PVC Intake Adaptor

• Concentric Termination

INDOOR MODELS

GTS-320-NIH, GTS-320-PIH

Condensing Technology Provides Significant Energy Cost Savings

Secondary Heat Exchanger is Made of Type 316L Stainless Steel

• Provides additional protection against corrosion

Durable Copper Primary Heat Exchanger

Continuous Maximum Flow Rates up to 8.0 GPM

ENERGY STAR

Qualified

Electronic IgnitionNo Pilot Light

Built-In Display Shows Operating Temperature Along with Diagnostic and Error Codes

Low NOx Emissions

Complies with Lead Plumbing Law

Outdoor Models include

OUTDOOR MODELS

GTS-320-NEH, GTS-320-PEH

Remote Control as a standard feature

Indoor Models include Remote Control and Power Cord as standard features

ANSI Z21.10.3 CSA 4.3

For more information on Tankless Condensing Units, contact:

State Water Heaters 500 Tennessee Waltz Parkway Ashland City, TN 37015

1-877-737-2840 Toll-free USA www.statewaterheaters.com

Warranty

• 12-year limited warranty on heat exchanger in residential applications

• 5-year warranty on all parts

SRGSS04311

CONDENSING MODELS

R E S I D E N T I A L

GAS CONSUMPTION INPUT INLET GAS PRESSURE

DIMENSIONS IN INCHES

SHIPPING

MODEL

NUMBER

FUEL TYPE

MINIMUM

BTU/H

MAXIMUM

BTU/H

MINIMUM

W.C.

MAXIMUM

W.C. HEIGHT WIDTH DEPTH

ENERGY FACTOR

MAX

GPM*

HOT/COLD

GAS CONN.

INDOOR MODELS

GTS-320-NIH Natural 13,000 180,000 5.0 10.5 0.91 8.0 3/4” NPT 25-3/5 18-1/2 12-2/5 73

GTS-320-PIH Propane 13,000 180,000 8.0 14.0 0.91 8.0 3/4” NPT 25-3/5 18-1/2 12-2/5 73

OUTDOOR MODELS

GTS-320-NEH Natural 13,000 180,000 5.0 10.5 0.91 8.0 3/4” NPT 25-3/5 18-1/2 12-2/5 70

GTS-320-PEH Propane 13,000 180,000 8.0 14.0 0.91 8.0 3/4” NPT 25-3/5 18-1/2 12-2/5 70

All dimension in inches. 15-150 psi Water Pressure. 40 psi or above recommended for maximum flow. *Current numbers based on factory testing; 0.4 GPM required for continuous fire after initial ignition.

OUTDOOR MODELS

4-1/2" (115mm)

120VAC 2-1/4" (58.2mm)

18-1/2" (470mm)

12-1/2" (320mm)

1-1/4" (29.2mm) COLD

4-5/8" (116.8mm) GAS

6-1/4" (159.1mm)HOT 5-5/8" (142.2mm)

Condensate drain port

6-1/4" (161.5mm)

1/2" (12.5mm)

GAS 6" (153.6mm)

HOT 7-1/4" (182.1mm)

120VAC 8-1/2" (216.3mm)

COLD 8-5/8" (220.6mm)

10-1/2" (266.8mm)

Condensate Drain Port

CLEARANCES: Top: 12”; Bottom: 12”; Front: 4”; Back: .05”; Sides: 3”

25-1/2" (649mm)

12-1/2" (316mm)

INDOOR MODELS

Male Ø4" (100.8mm)

6-5/8" (168.4mm)

120VAC 2-1/4" (58.2mm)

HOT 5-5/8" (142.2mm)

2-3/4" (69.1mm) INTAKE

18-1/2" (470mm)

12-1/2" (320mm)

3-1/2" (90mm)

Ø4" (102mm) Female

3/4" (18.8mm)

2-3/4" (71.8mm) EXHAUST

1-1/4" (29.2mm) COLD

4-5/8" (116.8mm) GAS

6-1/4" (159.1mm)

Condensate Drain Port

29-1/2" (751mm)

1/2" (12.5mm)

GAS 6" (153.6mm)

HOT 7-1/4" (182.1mm)

120VAC 8-1/2" (216.3mm)

COLD 8-5/8" (220.6mm)

10-1/2" (266.8mm)

Condensate drain port

CLEARANCES: Top: 36”; Bottom: 12”; Front: 4”; Back: .05”; Sides: 3”

12-1/2" (316mm)

25-1/2" (649mm)

APPROX.

WEIGHT

(LBS)

3-1/2" (90mm)

4-1/2" (115mm)

29-1/2" (751mm)

Flow Rate Vs. Temperature Rise

9.0

8.0

7.0

6.0

5.0

4.0

3.0

Flow Rate (gpm)

2.0

1.0

0.0

0 20 40 60 80 100 120 140

Temperature Rise (°F)

Set Temperature : 125°F & lower Set Temperature : 130 & higher

°F

Pressure Loss

Pressure Loss (psi)

0.0 1.0 2.0 3.0 4.0 5.0 6.0 7.0 8.0 9.0

Flow Rate (gpm)

Set Temperature : 125°F & lower Set Temperature : 130 & higher

°F

Head Feet

For complete information on limited warranties, consult written warranty or contact technical support at 1-877-737-2840. State Industries, Inc., reserves the right to make product changes or improvements without prior notice.

For more information on Tankless Condensing Units, contact:

State Water Heaters 500 Tennessee Waltz Parkway Ashland City, TN 37015

1-877-737-2840 Toll-free USA www.statewaterheaters.com