RESIDENTIAL
SELECT
ULTRA-LOW NOX
RESIDENTIAL GAS WATER HEATERS
®
Glasslined Tank
• Anode rods with stainless steel core
provides additional corrosion protection
Side Loop Connections
• This model comes standard with side loop
connections for optional hydronic heating
loop applications
CSA Certified and ASME
Rated T&P Relief Valve
Maximum Hydrostatic
Working Pressure: 150 PSI
80% Thermal Efficiency
Codes and Standards
• Design-certified according to ANSI
Z21.10.3-CSA 4.3 standards governing
storage-type water heaters
• California Energy Commission
• Meets the thermal efficiency and standby
loss requirements of the U.S. Department
of Energy and current edition of
ASHRAE/IESNA 90.1
• Design-certified by Underwriters
Laboratories
• Certified for use on combustible flooring
• Complies with SCAQMD Rule 1146.2
and other Air Quality Management
Districts with similar requirements of
14 ng/j or 20 ppm
Image Shows
Model GS675 URRBS
FEATURES
The GS6-75 residential gas water
heater meets Air Quality Management
District Requirements for NOx
emissions of 14 ng/j or 20 ppm. This
model is equipped with a prewired,
factory-mounted blower. This blower
provides more efficient control of heat
and helps ensure an adequate supply of
make-up air. Prior to ignition, the
control proves a working draft.
Factory-Installed Blower
• Control proves draft prior to ignition
• No draft hood or barometric
damper required
• Blower is factory-mounted with a 6-foot
power cord: requires 120V, 3 amp or less
electrical system connection
Intelli-Vent™ Gas Control
• Equipped with nearly indestructible silicon
nitride hot surface ignitor
• Advanced electronics for precise control
of water temperature
• Easy-to-understand system diagnostics
Rated as Category I Appliance
• Category I appliance: uses standard metal,
single-wall or “B” type vent
• May be common vented with other
Category I appliances
• Vent connects directly to blower outlet
For more information on Ultra-Low NOx, contact:
State Water Heaters
500 Tennessee Waltz Parkway
Ashland City, TN 37015
800-365-0024 Toll-free USA
www.statewaterheaters.com
Fully Automatic
Control System
• Auto-reset gas shutoff device prevents
excessive water temperature
• Adjustable thermostat with
120°F-160°F range
• Gas pressure regulator
Intelli-Vent™is a registered trademark of Emerson Electric Company
Six Year Limited Tank and
Parts Warranty
• For complete warranty information,
consult written warranty
SRGSS05212
RESIDENTIAL
TOP VIEW
N
Model
Gallon
Capacity
BTU
Input
Per Hour
Natural
BTU
Output
Per Hour
Natural
O
Recovery
90°F Rise
Gallons
Per Hour
A B C D E F G H J K L M N O
*INSTALL IN ACCORDANCE WITH LOCAL CODES
Dimensions in Inches
Approximate
GS675 URRBS 74 75,100 60,080 81 65-7/8 57-7/8 30-15/16 25-1/4 15-1/2 4 15-3/8 16 2-1/4 1 1/2 12-1/4 51 16-1/4 300
This model is not FVIR compliant.
Supplied with side loop connections standard.
SAMPLE SPECIFICATION
Natural gas water heater(s) shall be State ________________ or equal, with a storage capacity of __________ gallons, an input rating of ________BTUs per hour, a recovery rating
of ______GPH at 90°F rise and a maximum hydrostatic working pressure of ________ psi. Water heaters(s) shall be supplied with a factory-installed blower and 6-foot power cord;
control will prove draft prior to ignition. Glasslined water heater(s) shall also be protected against electrolytic corrosion by a factory-installed State anode rod. In addition, water heater(s)
shall be equipped with: 1) An Intelli-Vent
to-understand system diagnostics. 2) An auto-reset gas shutoff device, a gas pressure regulator, CSA Certified and ASME rated T&P relief valve. 3) Certification by Underwriters
Laboratories under Volume III tests for water heaters. 4) Design certification according to ANSI Z21.10.3 - CSA 4.3 standards governing storage-type water heaters. 5) Meets the
thermal efficiency and standby loss requirements of the U.S. Department of Energy and current edition of ASHRAE/IESNA 90.1 and meets Ultra-low NOx emissions of 14 ng/j or
20 ppm. 6) Have a 6-year limited tank and parts warranty against corrosion as outlined in the written warranty.
™
gas control system with silicon nitride hot surface ignitor, advanced electronics for more precise control of water temperature and easy-
Shipping
Weight
(LBS)
For complete information on limited warranties, consult written warranty or contact
the State Customer Care Center at 1-800-365-0024.
State Industries, Inc., reserves the right to make product changes or improvements without prior notice.
For more information on Ultra-Low NOx, contact:
State Water Heaters
500 Tennessee Waltz Parkway
Ashland City, TN 37015
800-365-0024 Toll-free USA
www.statewaterheaters.com
SRGSS05212 Page 2 of 2 © 2013 State Industries, Inc. Printed in U.S.A
Revised February 2013