SX-55EC
A Middleby Company
ELECTRIC TWO COMPARTMENT
CONVECTION STEAMER ON
CABINET BASE
Job Item#
Model
SX-34EC
SX-55EC
Compartments
2
2
Capacity
1-7 Pans
1-10 Pans
Standard Features
- Automatic generator blow down
- Delime mode power setting
- Deliming port for each generator, which is located on the rear of
the unit.
- Split water connections for simple hook up for a treated water
system.
- 28” high stainless steel construction cabinet base with operable
door for storage.
- Two electric, stainless steel generators operating at 0 psi (0 kPa)
with field replaceable element rated at:
SX-34EC - 7.5kW + 10kW
SX-55EC - 15 kW + 10kW
CONSTRUCTION SPECIFICATIONS
Southbend Convection Steamer with individual steam
generator for each cavity. C-CSA-US Certified and NSF
Approved. Model SX-34EC shall have 3 pan capacity on top
and 4 pan capacity on bottom. Model SX-55EC shall have 5
pan capacity on top and bottom. The steamer shall be
constructed of a satin finish stainless steel #304. The cooking
chamber is a one piece all welded, #316 stainless steel with
coved corners. The heavy duty door shall have an inner liner
of stainless steel with a full perimeter gasket seal, an outer
liner of one piece all welded stainless steel, and a positive
lock and seal mechanism with spring release. Each
compartment shall be provided with removable stainless
steel pan supports. A stainless steel drip trough shall be
integrally connected to drain to collect condensate when the
doors are opened.
The control housing shall be constructed of stainless steel
with a full access removable panel. Each compartment shall
have individual controls which include an illuminated three
way power switch (ON/OFF/Delime), a pilot ready light, a pilot
cooking light, a 60-minute electric timer which sounds an
audible signal at the end of the cooking cycle, and solid state
generator controls for each generator. Steam flow to the
cooking chamber shall be cut off when the door is opened
and reactivated when the door is closed.
SX-55EC
WATER QUALITY STATEMENT
Water quality is the major factor affecting the performance of your appliance. If you are unsure of water quality, consult a local
water treatment specialist and have the water analyzed. Your water supply must be within these general guidelines:
Total dissolved solids - less than 60 PPM
Total alkalinity - less than 20 PPM
Silica - less than 13 PPM
Chlorine -less than 1.5 PPM
pH Factor -7.0-8.5
Water which fails to meet these standards should be treated by installation of water conditioner.
FAILURE OR MALFUNCTION OF THIS APPLIANCE DUE TO POOR WATER QUALITY IS NOT COVERED UNDER WARRANTY
Form SX34EC
A Middleby Company
05/04 Printed in USA
Loading...