SRS-T55
SERVICE MANUAL
Ver 1.0 2001.03
SPECIFICATIONS
E Model
9-873-102-11
2001C0200-1
© 2001.3
ACTIVE SPEAKER SYSTEM
Sony Corporation
Audio Entertainment Group
General Engineering Dept.
SRS-T55
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be damaged by heat.
SECTION 1
GENERAL
TABLE OF CONTENTS
Specifications ........................................................................... 1
1. GENERAL ...................................................................... 2
2. DISASSEMBLY
2-1. Battery box ................................................................. 3
2-2. Speaker ....................................................................... 3
2-3. AMP board, DC Jack board ........................................ 4
3. DIAGRAMS
3-1. Printed Wiring Boards ................................................ 5
3-2. Schematic Diagram ..................................................... 6
6. EXPLODED VIEWS .................................................... 7
7. ELECTRICAL PARTS LIST..................................... 8
This section is extracted from
instruction manual.
LOCATION AND FUNCTION OF CONTROLS
2
SECTION 2
2
6
4
7
B
9
3
Screws (+ P2X6)
8
Screws (+2.6X6)
1
Screws (+ P2X5)
Cabinet (L), rear
Speaker
lead
Cabinet (L), front
Bar, tension
Shaft (L), rotary
Speaker (L)
(SP1)
A
5
Remove the speaker
lead from groove of
"Cabinet (L), front".
On attaching, set it
as shown in the
figure.
While pushing claw in the arrow
A direction, remove "Shaft (L),
rotary" by pushing it out in the
arrow B direction.
DISASSEMBLY
• The equipment can be removed using the following procedure.
Front section Speaker
Set
SRS-T55
Battery box
AMP board, DC Jack board
Note : Follow the disassembly procedure in the numerical order given.
2-1. BATTERY BOX
Lid, battery case
2
Front section
5
Screws (+ P2X6)
5
Screws (+ P2X6)
4
6
3
7
Remove soider
(four places
Battery box
1
2-2. SPEAKER
Note :Remove Speaker (R) in the same way.
3