Sony SLV-E930B, SLV-E930NP, SLV-E930UX, SLV-E930VC Service Manual

SLV -E930B/E930NP/E930UX/E930VC
SERVICE MANUAL
SUPPLEMENT-1
French Model
SLV-E930B
Spanish Model
SLV-E930NP
UK Model
SLV-E930UX
German Model
SLV-E930VC
File this supplement with the service manual.
Subject: EEP ROM INITIAL DATA INPUT
1. EEP ROM INITIAL DATA INPUT
When EEP ROM (IC472 on FR-119 board) was changed, make it sure to input the data shown below and to perform both “2-3-1. RF Switching Position Adjustment” and “2-5-1.1. AF Switching Po­sition Adjustment ”.
Input Method:
1) Connect the LANC jig (J-6090-051-A) to CN164 on MA-287 board.
2) Turn on the power.
3) Input Data: 80 in Address: 00 on Page: 1.
4) Input data on Page F as following table.
Page
Address BA
SLV-E930B 051
Data
F
B9B6B594930201
*Note for Extension
Note
070213F100250215 FF01137100200116SLV-E930NP 052 1601137100150314SLV-E930UX 050 FF01136100200214SLV-E930VC 050
(99-015)
5) Turn off the power
6) Disconnect the adjusting remote commander and LANC jig from the connector (CN164).
Note: When connecting or disconnecting LANC jig to CN164on
MA-287 board, first connect the adjusting remote com­mander (J-6082-053-B) to the jack on LANC jig before connecting LANC jig to CN164. Connection or disconnec­tion of the adjusting remote commander in the condition LANC jig is connected to CN164 causes IC LINK (PS001) to damage itself.
9-921-671-81
Sony Corporation
Home Video Company
Printed in Japan © 1999. 9
99I0546-1
Published by Quality Assurance Dept.
Loading...