Sony SLV-E920EG Service Manual

SERVICE MANUAL

SUPPLEMENT-1

SLV-E920EG

RMT-V195

Greek Model

File this supplement with the service manual.

Subject: EEP ROM INITIAL DATA INPUT

1. EEP ROM INITIAL DATA INPUT

When EEP ROM (IC472 on FR-119 board) was changed, make it
sure to input the data shown below and to perform both “2-3-1. RF
Switching Position Adjustment” and “2-5-1. 1. AF Switching Po­sition Adjustment ”.

Input Method:

1) Connect the LANC jig (J-6090-051-A) to CN164 on MA-287
board.

2) Turn on the power.

3) Input Data: 80 in Address: 00 on Page: 1.

4) Input data on Page F as following table.

20

01

F

B9B6B594930201

61

13

01

*Note for Extension

BA

FF

Note

Page

Address

Data

13 053

02

(99-011)

5) Turn off the power

6) Disconnect the adjusting remote commander and LANC jig
from the connector (CN164).

Note: When connecting or disconnecting LANC jig to CN164 on

MA-287 board, first connect the adjusting remote com­mander (J-6082-053-B) to the jack on LANC jig before
connecting LANC jig to CN164. Connection or disconnec­tion of the adjusting remote commander in the condition
LANC jig is connected to CN164 causes IC LINK (PS001)
to damage itself.

9-921-660-81

Sony Corporation

Home Video Company

Printed in Japan © 1999. 9

99I05050-1D

Published by Quality Assurance Dept.