Sony SGPT211US User Manual

Important product information

Owner’s Record

The model number and serial number are located on the rear panel of
your tablet device. Record the model and serial numbers in the space
provided here, and keep in a secure location. Refer to the model and
serial numbers when you call your Sony Service Center.
Model Number:
Serial Number:

Regulatory Information (USA)

If you have questions about this product, you can write to the Sony
Customer Information Service Center at 12451 Gateway Blvd., Fort Myers,
FL 33913, USA or find Sony Customer Service on the Web site at:
http://esupport.sony.com/EN/VAIO/ for customers in USA or
http://www.sony.ca/support/ for customers in Canada.

2

Declaration of Conformity

Trade Name: SONY
Model No.: SGPT211US/S, SGPT211CA/S

Responsible Party: Sony Electronics Inc.

Address: 16530 Via Esprillo, San Diego, CA

Telephone No.:
(For FCC-related matters only)

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1)

this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may cause undesired operation.

92127 U.S.A.

858-942-2230

The following FCC statements apply only to the version of this model
manufactured for sale in the USA. Other versions may not comply with
FCC technical regulations, and the FCC statements are not applicable in
Canada, including the Province of QUEBEC.

FCC Information (USA)

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that



to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.



Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.
Such modifications could void the user’s authority to operate the
equipment.

Only peripherals (input/output devices, terminals, printers, etc.) that
comply with FCC Class B limits may be attached to this product.
Operation with noncompliant peripherals is likely to result in interference
to radio and television reception.

All cables used to connect peripherals must be shielded and grounded.
Operation with cables connected to peripherals that are not shielded and
grounded may result in interference to radio and television reception.

For customers in USA and Canada

The following FCC statements apply only to the version of this model
manufactured for sale in the USA. Other versions may not comply with
FCC technical regulations, and the FCC statements are not applicable in
Canada, including the Province of QUEBEC.

GB

3

FCC/IC Radio Frequency Exposure

The available scientific evidence does not show that any health problems
are associated with using low power wireless devices. There is no proof,
however, that these low power wireless devices are absolutely safe. Low
power Wireless devices emit low levels of radio frequency energy (RF)
in the microwave range while being used. Whereas high levels of RF
can produce health effects (by heating tissue), exposure to low level RF
that does not produce heating effects causes no known adverse health
effects. Many studies of low level RF exposures have not found any
biological effects. Some studies have suggested that some biological
effects might occur, but such findings have not been confirmed by
additional research.

The following models (Table 1) have been tested and found to comply
with FCC/IC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules.

Table 1

Product Name FCC ID IC Number

SGPT211US/S
SGPT211CA/S

4

AK8SGPT211US
AK8SGPT211US

409B-SGPT211US
409B-SGPT211US

(FCC) Please refer to the SAR test report that was uploaded at FCC
website.
(IC) Please refer to the information that consult Safety Code 6, obtainable
from Health Canada’s Website.

This device and its antenna(s) must not be co-located or operating with
any other antenna or transmitter except Grant condition. Users are not
permitted to modify this transmitter device. Any unauthorized changes
made to this device could void your authority to operate this device.

IC RSS-210 (Canada)

This radio apparatus complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation of the device.

IC RSS-310 (Canada)

This device complies with RSS-310 of Industry Canada. Operation
is subject to the condition that this device does not cause harmful
interference.