Sony KV-28LS60B, KV-32LS60B Instruction Manual

4-206-694-71 (1)

FD Trinitron Colour Television

Instruction Manual

KV-32LS60B KV-28LS60B

NOTICE FOR CUSTOMERS

A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i.e. marked with 2 or @) must be used. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service centre.

How to replace the fuse

Open the fuse compartment with a blade screwdriver, and replace the fuse.

•

IMPORTANT

If the plug supplied is not suitable for the socket outlets in your home, it should be cut off and an appropriate plug fitted in accordance with the following instructions: The wires in this mains lead are coloured in accordance with the following code: Blue Neutral Brown Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. Do not connect either wire to the earth terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured green or green and yellow.

WARNING

• To prevent shock hazard, do not insert the plug cut off from the mains lead into a socket outlet. This plug cannot be used and should be destroyed.

• To prevent fire or shock hazard, do not expose the unit to rain or moisture.

• Dangerously high voltages are present inside the set. Do not open the cabinet. Refer servicing to qualified personnel only.

Introduction

Thank you for choosing this Sony FD Trinitron Colour Television.

Before operating the TV, please read this manual thoroughly and retain it for future reference.

• Symbols used in the manual:

• Important information.

• Information on a feature.

•

1,2...

Sequence of instructions.

• Shaded buttons on the remote control show you the buttons you have to press to follow the sequence of the instructions.

• Informs you of the result of instructions.

Table of Contents

Notice for Customers ..............................................................................................................................2

Introduction.............................................................................................................................................. 3

Safety Information................................................................................................................................... 4

Overview

Overview of Remote Control Buttons .................................................................................................. 5

Overview of TV Buttons ........................................................................................................................6

Installation

Inserting Batteries into the Remote Control ........................................................................................ 6

Connecting the Aerial and VCR ...........................................................................................................6

First Time Operation

Switching On the TV and Automatically Tuning ..............................................................................7

Menu system

Introducing and Using the Menu System............................................................................................9

Menu Guide:

Picture Adjustment .............................................................................................................................9

Sound Adjustment............................................................................................................................. 10

Sleep Timer.........................................................................................................................................11

Language/Country ........................................................................................................................... 11

Auto Tuning ....................................................................................................................................... 11

Programme Sorting ........................................................................................................................... 12

Programme Labels............................................................................................................................. 12

AV Preset ............................................................................................................................................12

Manual Programme Preset............................................................................................................... 13

Noise Reduction................................................................................................................................. 14

Auto Format ....................................................................................................................................... 14

AV3 Output ........................................................................................................................................15

TV Speakers........................................................................................................................................ 15

RGB Centring ..................................................................................................................................... 15

Picture Rotation .................................................................................................................................16

Teletext

Additional Information

Connecting Optional Equipment ........................................................................................................ 18

Using Optional Equipment ..................................................................................................................19

Remote Control Configuration for VCR/DVD.................................................................................20

Specifications.......................................................................................................................................... 21

Troubleshooting..................................................................................................................................... 22

...............................................................................................................................................17

Table of Contents

Safety Information

This set is to operate on a 220240V AC supply only. Take care not to connect too many appliances to the same power socket as this could result in ﬁre or electric shock.

Do not open the cabinet and the rear cover of the TV. Refer to qualiﬁed service personnel only.

Do not cover the ventilation openings of the TV For ventilation, leave a space of at least 10cm all around the set.

For environmental and safety reasons, it is recommended that the TV set is not left in standby mode when not in use. Disconnect from the mains.

For your own safety, do not touch any part of the TV, power lead or aerial lead during lightning storms.

Never place the TV in hot, humid or excessively dusty places. Do not install the TV where it may be exposed to mechanical vibrations.

Never push objects of any kind into the set as this could result in a ﬁre or electric shock. Never spill liquid of any kind on the set. If any liquid or solid object does fall through, do not operate the TV. Have it checked immediately by qualiﬁed personnel.

To prevent ﬁre or shock hazard, do not expose the TV to rain or moisture.

To prevent ﬁre, keep inﬂammable objects or naked lights (eg candles) away from the TV.

Clean the TV with a soft, lightly dampened cloth. Do not use benzine, thinner or any other chemicals to clean the TV. Do not scratch the TV screen. As a safety precaution, unplug the TV before cleaning it.

Place the TV on a secure stable stand. Do not allow children to climb on to it. Do not place the TV on its side or face up.

Safety Information

Pull out the power lead by the plug. Do not pull on the power lead itself.

Unplug the power lead before moving the TV. Avoid uneven surfaces, quick steps or excessive force. If the set has been dropped or damaged, have it checked immediately by qualiﬁed service personnel.

Take care not to place heavy objects on the power lead as this could result in damage. We recommend you wind any excess lead around the holders provided on the rear of the TV.

Do not cover the ventilation openings of the TV with items such as curtains or newspapers etc.

!º

!¡

!™

!£

!¢

!∞

!§

!¶

!•

!ª

Overview of Remote Control Buttons

!ª

!• !¶ !§ !∞

!¢

!£

!™

Recording button: If Media Selector is switched on VCR, press this button to record programmes.

Media Selector:

With this remote control you can operate not only this TV but also the main functions of your VCR or DVD. Switch on the device you want to operate and next press this button repeatedly to select the VCR, TV or DVD. A green light will be momentarily lit to indicate the chosen function.

Before the first time you want to control a DVD or VCR by using this remote control, you have to set it up depending on the brand of the device to be used. For more details, refer to chapter “Remote Control Configuration for VCR or DVD” on page 20.

Selecting channels: Press this button to select the next or previous broadcast channel.

Muting the Sound: Press this button to mute TV sound. Press again to restore the sound.

Adjusting TV volume: Press this button to adjust the volume of the TV.

Displaying the menu system: Press this button to display the menu on the TV screen. Press again to

remove the menu display from the TV screen.

Selecting TV mode: Press this button to switch off teletext or video input.

Selecting Sound effect: Press this button repeatedly to change the sound effect.

Selecting Picture mode: Press this button repeatedly to change the picture mode.

Displaying on Screen information: Press this button to display all on-screen indications. Press again

to cancel.

VCR or DVD on/off: Press this button to switch your VCR or DVD on or off.

To Temporarily Switch Off TV:

Press this button to temporarily switch off TV (the standby indicator on the TV lights up). Press again to switch on TV from standby mode.

3 4 5 6

7 8

9 !º

!¡

To save energy we recommend switching off completely when TV is not in use.

After 15 minutes without a signal and without any button being

pressed, the TV switches automatically into standby mode.

Selecting input source: Press this button repeatedly until the desired

input symbol of the source appears on the TV screen.

Selecting channels:

If Media Selector is switched to TV or VCR, press this button to select channels. For double-digit programme numbers, enter the second digit within 2.5 seconds.

a) If Media Selector is switched to TV:

Press this button to watch the last channel selected (watched for at least 5 seconds).

b) If Media Selector is switched to VCR:

For Sony’s VCR double-digit programme numbers, e.g. 23, press -/- -

first and then the buttons 2 and 3.

This button only works in Teletext mode.

Selecting screen format: Press this button repeatedly to change the

format of the screen. For more details refer to chapter “Auto Format” on page 14.

Selecting Teletext: Press this button to switch on teletext.

a) If Media Selector is switched to TV:

• When MENU is switched on, use these buttons to operate the menu system. For details refer to “Introducing and Using the Menu System” on page 9.

• When MENU is switched off, press OK to show a channel overview. Then press or to select the channel and then press again the OK button to watch the selected channel.

b)If Media Selector is switched to VCR or DVD:

Using these buttons you can control the main functions of your VCR or DVD.

Besides TV functions, all coloured buttons as well as green symbols are also used for Teletext operation. For more details, please refer to “Teletext” section of this instruction manual.

Overview

Overview of TV Buttons

Auto Start Up Button

S video Input jack

Press on the mark on the door flap to reveal the control panel.

Selecting Input source

Video Input jack

Programme Up or Down Buttons (Selects TV channels)

Volume control buttons

Audio Input jacks

Standby indicator

On/Off

switch

Headphones

jack

Inserting Batteries into the Remote Control

Make sure you insert the supplied batteries using the correct polarities. Always remember to dispose of used batteries in an environmental friendly way.

Connecting the Aerial and VCR

Connecting cables are not supplied.

VCR

OUT IN

Overview-Installation

Scart lead is optional.

For more details of VCR connection, please refer to the section “Connecting Optional Equipment” of this instruction manual.

Switching On the TV and Automatically Tuning

The first time you switch on your TV, a sequence of menu screens appear on the TV enabling you to: 1) choose the language of the menu screen, 2) choose the country in which you wish to operate the TV, 3) adjust the picture slant 4) search and store all available channels (TV Broadcast) and 5) change the order in which the channels (TV Broadcast) appear on the screen. However, if you need to change any of these settings at a later date, you can do that by selecting the appropriate option in the (Set Up menu) or by pressing the Auto Start Up Button on the TV set.

Connect the TV plug to the mains socket (220-240V AC, 50Hz) The first time that the TV set is connected, it is usually turned on. If the TV is off, press the on/off button on the TV set to turn on the TV. The first time you switch on the TV , a Language menu displays automatically on the TV screen.

Press the or button on the remote control to select the language, then press the OK button to confirm your selection. From now on all the menus will appear in the selected language.

The Country menu appears automatically on the TV screen. Press the or button to select the country in which you will operate the TV set, then press the OK button to confirm your selection.

• If the country in which you want to use the TV set

does not appear in the list, select “-” instead of a

country.

• In order to avoid wrong teletext characters for Cyrillic languages we recommend to select Russia country in the case that your own country does not appear in the list.

Because of the earth’s magnetism, the picture might slant.

The

Picture Rotation

menu allows you to correct the

picture slant if it is necessary.

If it is not necessary, press or to select

necessary

If it is necessary, press or to select

and press OK.

Not

Adjust now

then press OK and correct any slant of the picture between –5 and +5 by pressing or . Finally press

to store.

Language

Svenska Norsk English Nederlands Français Italiano

Select Language:

Country

Sverige Norge

Italia Deutschland Österreich

Select country:

If picture slants, please

adjust picture rotation

Not necessary

Adjust now

continued...

First Time Operation

+ 16 hidden pages