Sony cdp-m11c, hmd-m11, sa-n11 Service Manual
MICROFILM
US Model
Canadian Model
AEP Model
UK Model
E Model
CMT-M11C
SERVICE MANUAL
COMPACT COMPONENT SYSTEM
• CMT-M11C is composed of following models.
As for the service manual it is issued for each component model, then, please refer to it.
SPECIFICATIONS
General
Power requirements
US, CND model: 120 V AC, 60 Hz
AEP, UK model: 220 – 230 V AC, 50/60 Hz
E, HK, SP, MY model:
120 V or 220 – 240 V AC, 50/60 Hz
adjustable with voltage selector
Power consumption
Tuner/Preamplifier/Minidisc deck section:
US, CND model: 19 W
Except US, CND model: 20 W
Active speaker system: 25 W
Dimensions
Tuner/Preamplifier/Minidisc deck section:
Approx. 142 × 125 × 256 mm
(w/h/d) (5
5
/8 × 5 × 10 inches)
incl. projecting parts and controls
CD Player:
Approx. 142 × 125 × 263.5 mm
(w/h/d) (5
5
/8 × 5 × 10 inches)
Active speaker system:
Right: Approx. 125 × 205 × 212 mm
(w/h/d) (5 × 8
1
/8 × 7 7/8 inches) incl.
projecting parts and controls
Left: Approx. 125 × 205 × 198 mm
(w/h/d) (5 × 8
1
/8 × 7 7/8 inches) incl.
projecting parts and controls
Mass
Tuner/Preamplifier/Minidisc deck section:
Approx. 3.3 kg (6 lb 10 oz)
CD Player:
Approx. 2.6 kg (5 lb 4.7 oz)
Active speaker system:
Right : Approx. 3.0 kg (6 lb 10 oz)
Left : Approx. 1.8 kg (3 lb 15 oz)
Supplied accessories
Sony RM-SM11 Remote (1)
Sony SUM-3 (NS) batteries (2)
Audio cord 1 m (1)
Digital optical cable (1)
Speaker cable (1)
AM loop antenna (1)
FM loop antenna (1)
Power adaptor (1) (SP model)
Design and specifications are subject to change without notice.
• Abbreviation
CND : Canadian
HK : Hong Kong
MY : Malaysia
SP : Singapore
COMPONENTS MODEL NAME FOR THIS SYSTEM
SET
COMPONENT
TUNER/PREAMPLIFIER/
MINIDISC DECK
CD PLAYER
ACTIVE SPEAKER
SYSTEM
CMT-M11C
US CND AEP UK E HK MY SP
HMD-M11
CDP-M11C
SA-N11
– 2 –
SECTION 1
AGING MODE
1-1. CONNECTION AND PREPARATION
Before entering the aging mode, connect as shown below, load a
writable disc (MD) into the HMD-M11 and set three discs (CD)
into the CDP-M11C.
1-3. RELEASING THE AGING MODE
In the aging mode, press any button on HMD-M11, then press
POWER button on HMD-M11, and the power goes in OFF sta-
tus, then the set becomes ready for normal operation.
1-4. OPERATION IN AGING MODE
When the aging mode is activated, 4 cycle aging ↔ 10 minute CD
sync. dubbing are repeatedly executed until any button is pressed.
During a cycle aging, normal display is made (if an error occurs,
the operation stops with an error message kept displayed). During 10 minute CD sync. dubbing, MD retry count and a cause of
retry are displayed with a hexadecimal number, and also CD sound
skip count is displayed.
84218421 Description
Bit b7 b6 b5 b4 b3 b2 b1 b0
00000000 00 (Not used) (Not used)
00000001 01 shock Track was skipped due to a shock
00000010 02 ADIP error ADIP error occurred more than 5 times successively
00000100 04 address error ADIP addresses are not serial
Decimal
00001000 08 Din unlock Digital input is unlocked
00010000 10 focus Focusing failed
00100000 20 IV-R ABCD signal level exceeded the specified range
01000000 40 CLV unlock CLV is unlocked (CLV is out of range)
10000000 80 cannot access Access failed
Hexa-
Lower BitUpper Bit
Table 1-1. Description of Retry Cause Display
Name of Retry
Cause
Hexa-
decimal
Note: The contents of disc are all erased, if a recorded disc is
used in the aging mode.
1-2. SETTING THE AGING MODE
With the power in OFF status, press =0 button and
VOL + button on the HMD-M11 simultaneously, and the aging
mode is activated.
CDP-M11C
Compact Disc
Player
HMD-M11
Mini-disc deck/
Tuner/Preamp
optical cable
System control cable
(Attached to HMD-M11)
AC IN
MD
CD
Retry count
Cause of retr
y
Sound skip count
Loading...