Sony CPD-G220S Operating Instructions

4-081-489-11 (1)

Trinitron Color Computer Display

Operating Instructions Mode d’emploi Manual de instrucciones

US FR ES

CPD-G220R CPD-G220S

Owner’s Record

The model and serial numbers are located at the rear of the unit. Record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. Model No.

Serial No.

WARNING

To prevent fire or shock hazard, do not expos e the unit to rain or moisture.

Dangerously high voltages are present inside the unit. Do not open the cabinet. Refer servicing to qualified personnel only.

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for

help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

IMPORTADOR (Para Mexico unicamente/For Mexico only)

Sony Electronicos de Mexico, S.A. de C.V. Henry Ford No.29 Fraccionamiento San Nicolas, Tlalnepantla Estado de Mexico, CP54030 Tel.: 321-1000 R.F.C. SEM-941001-BJA

IMPORTANTE

Para prevenir cualquier mal funcionamiento y evitar daños, por favor, lea detalladamente este manual de instrucciones antes de conectar y operar este equipo.

INFORMATION This product complies with Swedish National Council for Metrology (MPR) standards issued in December 1990 (MPR II) for very low frequency (VLF) and extremely low frequency (ELF).

INFORMATION Ce produit est conforme aux normes du Swedish National Council for Metrology de décembre 1990 (MPR II) en ce qui concerne les fréquences très basses (VLF) et extrêmement basses (ELF).

INFORMACIÓN Este producto cumple las normas del Consejo Nacional Sueco para Metrología (MPR) emitidas en diciembre de 1990 (MPR II) para frecuencias muy bajas (VLF) y frecuencias extremadamente bajas (ELF).

NOTICE

This notice is applicable for USA/Canada only. If shipped to USA/Canada, install only a UL LISTED/CSA LABELLED power supply cord meeting the following specifications: SPECIFICATIONS

Plug Type Nema-Plug 5-15p Cord Type SVT or SJT, minimum 3 Length Maximum 15 feet Rating Minimum 7 A, 125 V

× 18 AWG

NOTICE

Cette notice s’applique aux Etats-Unis et au Canada uniquement. Si cet appareil est export* aux Etats-Unis ou au Canada, utiliser le cordon d’alimentation portant la mention UL LISTED/CSA LABELLED et remplissant les conditions suivantes: SPECIFICATIONS

Type de fiche Fiche Nema 5-15 broches Cordon Type SVT ou SJT, minimum 3 Longueur Maximum 15 pieds Tension Minimum 7 A, 125 V

As an

ENERGY STAR Partner, Sony

Corporation has determined that this product meets the guidelines for energy efficiency.

This monitor complies with the TCO’99 guidelines.

For questions regarding your pro duct or for the S ony Servic e Center nearest you call:

or write to: Sony Customer Information Center 1 Sony Drive, Mail Drop #T1-11, Park Ridge, NJ 07656 USA

The number below is for FCC related matters only.

1-800-222-SONY(7669)

× 18 AWG

ENERGY STAR

Declaration of Conformity

Trade Name: Sony Model No.: CPD-G220 Responsible Party: Sony Electronics Inc. Address: 1 Sony Drive, Park Ridge, NJ. 07656 USA Telephone No.: 201-930-6972

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. A to Z.

Can be replaced with any letter from

Table of Contents

Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Identifying parts and controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6

Step 1: Connect your monitor to your computer . . . . . . . . . . . . . . . 6

Step 2: Connect the power cord. . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Step 3: Turn on the monitor and computer . . . . . . . . . . . . . . . . . . . 7

Selecting the on-screen menu language (LANGUAGE). . . . . . . . . . 7

Customizing Your Monitor . . . . . . . . . . . . . . . . . . . . . . . .8

Navigating the menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

Adjusting the brightness and contrast. . . . . . . . . . . . . . . . . . . . . . . . 9

Adjusting the size and the centering of the picture (SIZE/CENTER) 9

Adjusting the shape of the picture (GEOMETRY) . . . . . . . . . . . . . 10

Adjusting the color of the picture (COLOR) . . . . . . . . . . . . . . . . . . 10

Adjusting the convergence (CONVERGENCE) . . . . . . . . . . . . . . . 10

Changing the OSD language (LANGUAGE) . . . . . . . . . . . . . . . . . 10

Additional settings (OPTION) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

•Trinitronâ and FD Trinitronâ are registered trademarks of Sony Corporation.

• Macintosh is a trad emark licensed to Apple Computer, Inc., registered in the U.S.A. and other countries.

• Windows trademarks of Mi cros of t Co r porat io n in the United States and other countries.

• IBM PC/AT and VGA are registered trademarks of IBM Corporation of the U.S.A.

• VESA and DDC Video Electronics Standard Association.

ENERGY STAR is a U.S. registered

• mark.

• All other product names ment i one d herein may be the trademarks or registered trad emarks of their r espective companies.

•Furthermore, “ mentioned in each case in this manu al .

and MS-DOS are registered

are trademarks of the

ä” and “â” are not

Technical Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12

Preset and user modes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Power saving function. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12

If thin lines appear on your screen (damper wires). . . . . . . . . . . . . 12

On-screen messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Trouble symptoms and remedies . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Self-diagnosis function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15

Appendix. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i

Preset mode timing table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i

TCO’99 Eco-document . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i

Precautions

Warning on power connections

• Use the supplied power cord. If you use a different power cord,

be sure that it is compatible with your local power supply.

For the customers in the U.S.A.

If you do not use the appropriate cord, this monitor will not conform to mandatory FCC standards.

Example of plug types

for 100 to 120 V AC

• Before disconnecting the power cord, wait at least 30 seconds

after turning off the power to allow the static electric ity on the screen’s surface to discharge.

• After the power is turned on, the screen is demagnetized

(degaussed) for about 5 seconds. This generates a strong magnetic field around the screen which may affect data stored on magnetic tapes and disks placed near the monitor. Be sure to keep magnetic recording equipment, tapes, and disks away from the monitor.

for 200 to 240 V AC

Maintenance

• Clean the screen with a soft cloth. If you use a glass cleaning liquid, do not use any type of cleaner containing an anti-static solution or similar additive as this may scratch the screen’s coating.

• Do not rub, touch, or tap the surface of the screen with sharp or abrasive items such as a ballpoint pen or screwdriver. This type of contact may result in a scratched picture tube.

• Clean the cabinet, panel and controls with a soft cl oth lightly moistened with a mil d detergent solution. Do not use any type of abrasive pad, scouring powder or solvent, such as alcohol or benzene.

Transportation

When you transport this monitor for repair or shipment, use the original carton and packing materials.

Use of the tilt-swivel

This monitor can be adjusted within the angles shown below. To find the center of the mon itor ’s turning ra dius, a lign the center o f the monitor’s screen with the centering line on the stand. Hold the monitor at the bott om with bo th ha nd s whe n yo u tu rn it horizontally or vertically. Be careful not to pinch your finger s a t the back of the monitor when you tilt the monitor up vertically.

The equipment should be in stalled near an easily accessible outlet.

Installation

Do not install the monitor in the following places:

• on surfaces (rugs, blankets, etc.) or near materials (curtains, draperies, etc.) that may block the ventilation holes

• near heat sources such as radiators or air ducts, or in a pla ce subject to direct sunlight

• in a place subject to severe temperature changes

• in a place subject to mechanical vibration or shock

• on an unstable surface

• near equipment which generates magnetism, such as a

transformer or high volta g e po w er lin es

• near or on an electrically charged metal surface

• in a dusty or smoky environment

• into a wall or enclosure

Protection

• Do not put foreign objects into the monitor.

• Disconnect the monitor if environment exceeds 60°C/140°F.

• Ensure AC power cord is not trapped under furniture, TV, etc.

• Do not overload wall outlets, extensio n co rd s, or conven ie nce

receptacles beyond their capaci t y.

90°

Centering line

15°

90°

5°

Identifying parts and controls

See the pages in parentheses for further details.

RearFront

1 MENU/OK button (page 9)

The MENU/OK button is used to displa y the main MENU on your screen.

2 Joystick (page 9)

The joystick is used to navigate the menu and make adjustments to the monitor, including brightn ess and contrast adjustments.

3 1 (power) switch and indicator (pages 7, 12, 15)

This button turns the monitor on and off. The power indicator lights up in green when the monitor is turned on or lights up in orange when the monitor is in power saving mode.

Side

For CPD-G220S model only

VOL

4 Volume (VOL) control

This control adujster is used to adjust the volume. Move the adjuster to the right to increase the volume. Move the adjuster to the left to decrease the volume.

5 Headset output

You can listen to the audio signals from your computer using headphones (not supplied). The speaker turns off when headphones are connected to the headphones jack. Adjust the volume using the volume control.

AUDIO IN

AC IN

7 AC IN connector (page 6)

This connector provides AC po wer to th e monitor.

8 Video input connector (HD15) (page 6)

This connector inputs RGB video signals ( 0.700 Vp-p, positive) and sync signals.

1 2 3 4

876

11 12 13 14 15

Pin No. Signal

1Red 2 Green

(Sync on Green) 3Blue 4 ID (Ground) 5 DDC Ground* 6 Red Ground 7 Green Ground 8 Blue Ground 9 DDC Host 5V* 10 Ground 11 ID (Ground) 12 Bi-Directional Data (SDA)* 13 H. Sync 14 V. Sync 15 Data Clock (SCL)*

* DDC (Display Data Channel) is a standard of V E SA .

6 AUDIO IN input

You can listen to music, sounds, and other audio f iles using the speaker in your monitor. Connect the AUDIO IN jack to the audio out jack of your computer’s sound card using the miniplug cord (supplied).

Setup

Before using your monitor, check that the following accessories are included in your carton:

• Power cord (1)

• Audio miniplug cord (1)

for CPD-G220S model only

• Warranty card (1)

• Notes on cleaning the screen ’s surface (1)

• This instruction manual (1)

• Notice of Macintosh adapter availability (1)

Step 1:Connect your monitor to

your computer

Turn off the monitor and computer before connecting.

Note

• Do not touch the pins of th e video cable connector a s thi s mi ght bend the pins.

x Connecting to an IBM PC/AT or compatible

computer

x Connecting to a Macintosh or compatible

computer

AC IN

Macintosh adapter (not supplied)

to video output

AC IN

IBM PC/AT or compatible computer

Macintosh or compatible computer

* Please refer to the Notice of Macintosh adapter availability.

Step 2:Connect the power cord

With the monitor and computer switched off, first connect the power cord to the monitor, then connect it to a power outlet.

to video output

AC IN

to AC IN

to a power outlet

power cord (supplied)

+ 13 hidden pages