SONANCE VISUAL PERFORMANCE SERIES
EXTREME SPEAKERS INSTRUCTION MANUAL VPXT6 | VPXT6R | VPXT6R SST | VPXT8R
Box Contents
VPXT6 or VPXT6R or VPXT8R
(1)Quickstart guide / cutout template
(2)Speakers
(2) Paintable grilles
Or
VPXT6R SST
(1) Quickstart guide / cutout template
(1) Speaker
(1) Paintable grille
Introduction
Thank you for purchasing Sonance Visual Performance Series Speakers. This guide covers the following speaker models: VPXT6 (6” Rectangular), VPXT6R (6” Round), VPXT6R SST (6” Round, Single-Stereo Technology®) and VPXT8R (8” Round).
Before Installation: Retro-fit
1.Determine the location for the speaker.
2.Perform an obstruction survey to be certain that there are no studs, conduit, pipes, heating ducts, pocket doors
or air returns in the wall cavity that will interfere with the speaker.
3.Position the included cutout template where the speaker is to be located and pencil an outline on the wall or ceiling.
•If you are unsure about obstructions, drill a small hole in the center of the outline and insert a coat hanger wire into the hole to feel-around for possible obstructions.
4.Cut the mounting hole using tools appropriate for the construction, and run the speaker wires from the mounting hole to the amplifier location.
NOTE: CONSULT LOCAL BUILDING CODES BEFORE RUNNING SPEAKER WIRES THROUGH WALLS.
Connection Terminals |
Figure 1: Connection Terminals |
2.The speaker’s connector posts are spring-loaded. Push the top of each connector post down to open the
connector and insert the exposed wires into the holes in the posts (see Figure 1).
3.The speaker’s positive post is labeled with a red dot; the negative post is labeled with a black dot.
•The VPXT6R SST has two sets of connection terminals, located on opposite sides of the crossover board.
4.After making all connections, double-check that you connected amplifier “+” to speaker “+” and amplifier “–” to speaker “–”.
5.Make sure all the Roto-Lock toggle feet are retracted so that they are tucked within the mounting hole’s border.
Figure 2: Roto-Lock Toggle Feet Retracted |
NOTE: THE ROTO-LOCK SYSTEM CAN ACCOMMODATE A WALL MATERIAL THICKNESS OF 1 1/4” (32MM) WITH THE TOGGLE FOOT CAP REMOVED THE SYSTEM CAN ACCOMMODATE A WALL MATERIAL THICKNESS OF 1 3/4” (44MM). TO REMOVE THE CLAMP FEET, USE A SMALL SCREWDRIVER TO GENTLY RELEASE THE LOCKING LEVERS (FIGURE 3, LEFT). THEN REMOVE THE FEET FROM THE CLAMPS (FIGURE 3, RIGHT).
Installation
Sonance Visual Performance Series Extreme speakers feature an exclusive integral RotoLock® mounting system for quick mounting directly into existing walls and ceilings.
1. Strip 1/4” – 1/2” (6mm – 13mm) of insulation from each speaker lead. Twist the strands or tin the exposed wire with solder to ensure that there are no stray strands.
NOTE: STRAY STRANDS THAT TOUCH EACH OTHER CAN CAUSE A |
|
SHORTCIRCUIT THAT CAN DAMAGE THE AMPLIFIER. |
Figure 3: Removing the Roto-Lock Clamp Feet |
1