Smiths Sargasso A Installation Manual

Sargasso Range

Installation manual

Issue 001 | January 2018

ENGLISH | UK | IRL | SmithsEP.co.uk

Sargasso A

Declaration of conformity

EC Declaration of conformity

Radiant Heating and Cooling Solutions Ltd
Units 1 -3, Farrow Road, Great Barr
Birmingham, B44 9HE
Mobile: [phone]
Tel: [phone]

This declaration conrms that the Radiant
Heating panel has been manufactured in a
facility certied to the requirements of ISO
9001: 2015 (BSI Certicate FM51223 refers)
and scoped for the Manufacture of Radiant
Heating Panels for the Construction Industry.

The product has been independently tested
(WSP report no 15.55.RHC.101 refers) and
meets the requirements as generally specied
in EN 14037-2: 2016 for:

Free hanging heating and cooling surfaces for
water with a temperature below 120°C.

Pre-fabricated ceiling mounted radiant panels for
space heating.

Test method for thermal output.

This declaration is issued under the sole
responsibility of the manufacturer.

Bob Parker
Sales Director

Date 05.12.17

Introduction

This product has been assembled and prepared
for easy installation.

In the event of any visible damage, please contact
us on [phone].

Please leave this Installation Guide with the owner
of the property.

Contents

Introduction 2

Symbols used in this guide 2

Declaration of conformity 2

Important safety and installation instructions 3

Application 4

Product Information 5

Installation 6

Registering your product 7

Disposal 7

After sales and spares 7

Symbols

This manual contains information and
prescriptions marked by the following symbols.

Ignoring these safety provisions
marked by the symbol “caution:
hazard” may endanger the safety
of people.

The removal of the screws can
cause the output of hot uids
under high pressure from heating
system. Drain the system or close
the isolating valves.

High temperature surface. Take
utmost care to prevent people
from getting in contact with the
hot surfaces of the appliance.

02 | SmithsEP.co.uk | Issue 001 - January 2018

Issue 001 - January 2018 | SmithsEP.co.uk | 03

Important safety and installation instructions

Prior to installation, read these installation and operating instructions. The installation and operation should
also be in accordance with national regulations and accepted codes of good practice.

This product is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the product by a person
responsible for their safety. Children should be supervised to ensure that they do not play
with the product.

To guard against injury, basic safety precautions should be observed, including the
following:

1. Read and follow all safety instructions and all the important notices on the product
before installing, using and maintaining the product. Failure to do so may cause
personal injury or damage to the product or installation.

2. Risk of scalding. To avoid injury before any servicing operation wait until the water has
cooled inside the product. Do not touch the uid or the product when temperature
is higher than 60°C.

3. Improper use.
This is an product to be used in heating systems with clean water without
abrasive particles.

4. Installation.
The product must be mounted in a stable/xed position in a dry, frost-free and
waterproof place, with sufcient ventilation around it. Make sure that the product is
securely and correctly installed before operating it and that there is enough room
around it for maintenance operations, dismantling, checking for free inspection.

Non-observance of the safety instructions results in the loss of any claims to damages.

The indicated limit values are binding and cannot be exceeded for any reason whatsoever.

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.