Singing Machine SDL485W, SDL485BK User Manual
TM
SDL485BK/SDL485W REMIX
INSTRUCTION MANUAL
www.singingmachine.com
The Singing Machine® is a registered trademark of The Singing Machine Co., Inc.
Warnings
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The Caution marking is located on the bottom panel.
DANGEROUS VOLTAGE: The lightning flash with arrowhead
symbol within an equilateral triangle is intended to alert the
user to the presence of uninsulated dangerous voltage within
the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
ATTENTION: The exclamation point within an equilateral
triangle is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions
in the literature accompanying this product.
DRIPPING WARNING: This product shall not be exposed to dripping or
splashing, and no objects filled with liquids, such as vases, shall be placed
on the product.
VENTILATION WARNING: The normal ventilation of the product shall not be
impeded for intended use.
SAFETY VERIFICATION: This device is made and tested to meet safety
standards of the FCC, requirements and compliance with safety
performance of the U.S. Department of Health and Human Services and
also with FDA Radiation Performance Standards 21 CFR Subchapter.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT AND FULLY INSERT.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
FCC WARNING: This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The rating information is located at the back of the unit.
INDUSTRY CANADA NOTICE:
This device complies with Industry Canada Iicense-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
CAN ICES-3(B)/NMB-3(B)
Important Safety Information
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all Instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance
with the Manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of the polarized or groundingtype plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. When the provided plug does not fit into your
outlet, consult an electrician for replacement of the obsolete
outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket,
or table specified by the manufacturer, or
sold with the apparatus. When a cart is
used, use caution when moving the cart/
apparatus combination to avoid injury from
tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods of
time.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
15. WARNING: To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture. Do not place objects
filled with water, such as a vase, on the apparatus.
16. The AC mains plug is used as the power disconnect device and
it should remain readily accessible and operable during intended
use. In order to completely disconnect the apparatus from
power, the mains plug should be completely removed from the
AC outlet socket.
17. CAUTION: To reduce the risk of fire or explosion, do not expose
batteries to excessive heat such as sunshine, fire or other
— 1 —
heat sources.
Included
Please make sure the following items are included.
Main Unit
Singing Machine Flash Drive
Manual
Wired Microphone
Cradle
AC Adapter
— 2 —
Location of Controls (Front/Side)
23
10
11
12
13
14
1
2
3
4
5
6
7
8
9
15
16
17
18
19
20
21
22
23
24
25
26
27
28
3
1. Cradle
2. MASTER VOLUME
Control
3. Lights
4. Power Indicator
5. ON/OFF Button
6. FUNCTION Button
7. LIGHTS Button
8. MIC VOL + Button
9. RECORD n Button
10. ECHO – Button
11. MIC VOL – Button
12. ECHO + Button
13. Function Indicator
14. SMC USB Slot
15. SD Card Slot (for
Record only)
16. LINE IN Jack
17. PAIR Button
18. MIC 1 Jack
19. Bluetooth Indicator
20. MIC 2 Jack
— 3 —
21. VOCAL Button
22. MENU Button
23. Mic Holders
24. Navigation UP 5
Button
25. ENTER/ Button
26. Navigation RIGHT
Button
27. Navigation DOWN
Button
28. Navigation LEFT
Button
Location of Controls (Rear)
1. Right Tower Speaker Jack 4. HDMI Jack
5. LINE IN Jack2. Left Tower Speaker Jack
3. AC Power Cord
4
5
2
1
3
1
2
1. HDMI Jack
2. DC IN Jack
Location of Controls (Playback Display)
Song
Total Time
— 4 —
Current
Playlist
Lead Vocal Status
Master Volume: 0-20
Echo Control: 0-8
Mic Volume: 0-8
Record
Status
Playback Status
Song Title
Song
Elapsed Time
Connection
Connecting the Microphone(s)
Connection
Connecting the Unit to a TV
Microphones:
Connect a microphone into MIC 1 Jack u
1
as well as MIC 2 Jack v (when desired)
located at the side of the unit.
2
Note:
Do not drop or tap the Mic as damage to
the Mic or speakers may occur. Do not
twirl the microphone by the cord as it will
cause damage to the encased wiring.
HDMI Jack (Out)
Rear of External TV
HDMI Jack (In)
HDMI IN 1
HDMI Cable
— 5 —
To output the video, lyrics and
audio to your TV, perform the
following steps:
Plug the HDMI cable (not included)
into the HDMI Jack on the back of
the unit. Plug the other end of the
HDMI cable into the HDMI input
on your TV.
Notes:
• This unit can be used with or
without a TV, but it is highly
recommended to use a TV in
order to utilize all the features.
• Also refer to the TV’s or external
unit’s User Guide.
Connection
HDMI Cable
Rear of External TV
HDMI Jack (Out)
HDMI Jack (In)
HDMI IN 1
2
Connecting to AC Power
Connecting to LINE IN Jack
LINE IN
AUDIO OUTPUT
/ HEADPHONE JACK
To External Unit
Insert the small end of the AC
adapter into the DC IN Jack on
the rear of the unit. Insert the
other end (with the 2 blades) into
a conveniently located AC outlet
having 120V AC, 60Hz.
Note:
Make all connections before
connecting to AC power.
Connect an external device
by using an appropriate cable
(3.5mm audio cable not included)
as shown.
Note:
See page 23 to select and use the
LINE IN function.
Connecting the Cradle
Insert Cradle by gently sliding it
downward while lining up the pins
of the Cradle with the holes on
the top of the unit.
— 6 —
Singing Machine USB Flash Drive
Included with the system is a
Singing Machine USB Flash
Drive which is used for storing
Karaoke songs as well as
recordings from this unit.
There are two songs included on
the Singing Machine USB Flash
Drive but you can access the
Karaoke Store for many more
songs. Just follow the Welcome
Kit Instructions!
Inserting the USB Flash Drive or an SD Card
Before you insert the Singing
Machine USB Flash Drive, make
sure to remove it from its stand
which will reveal the USB plug.
— 7 —
Insert it into the USB slot on the
unit with the face towards the
top of the unit. If you would like
to have more memory capacity
for the recording function, you
can insert an SD Card with up to
32 GB (not included) to store the
recorded files as well.
Note:
If both an SD Card and a USB
Flash Drive are inserted, the unit
will automatically record onto the
SD card.
Karaoke Store
PC Installation
The Karaoke Store application can be installed on Microsoft Windows computers running
Vista, Windows 7 and Windows 8 or higher. The Karaoke Store application requires
connection to the Internet (a high-speed connection is recommended).
Insert the Singing Machine USB
1
Flash Drive into a powered USB
slot on your computer.
Double click the file named,
2
“Karaoke_Store_Win_Setup”.
Follow the online instructions to install the
3
software on your computer.
After installing, open your Program’s folder
4
and open the Karaoke Store file (in the
computer’s Application folder).
Double click Karaoke Store to
5
open the software.
On this page you can now
6
sign up and enter your code
for 10 free downloads and
then download them to your
computer and/or USB drive for
playing on your new Singing
Machine!
— 8 —
Loading...