iSM395bt-ENG-v4_Layout 1 7/26/13 8:50 AM Page 1
Warnings
CAUTION
ISK OF ELECTRIC SHOCK
R
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
NSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
I
The Caution marking is located on the bottom panel.
DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol
within an equilateral triangle is intended to alert the user to the
resence of uninsulated dangerous voltage within the product’s
p
enclosure that may be of sufficient magnitude to constitute a risk of
electric shock to persons.
ATTENTION: The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important operating and
aintenance (servicing) instruc tions in the literature accompanying
m
this product.
DRIPPING WARNING: This product shall not be exposed to dripping or
splashing, and no objects filled with liquids, such as vases, shall be placed on
the product.
VENTILATION WARNING: The normal ventilation of the product shall not be
impeded for intended use.
SAFETY VERIFICATION: This device is made and tested to meet safety
standards of the FCC, requirements and compliance with safety performance
of the U.S. Department of Health and Human Services and also with FDA
Radiation Performance Standards 21 CFR Subchapter.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.
CC WARNING: This equipment may generate or use radio frequency
F
nergy. Changes or modifications to this equipment may cause
e
harmful interference unless the modifications are expressly approved
in the instruction manual. The user could lose the authority to operate
this equipment if an unauthorized change or modification is made.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
ause harmful interference, and (2) this device must accept any
c
nterference received, including inter ference that may cause
i
undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
enerates, uses and can radiate radio frequency energy and, if not
g
installed and used in accordance with the instructions, may cause
armful interference to radio communications. However, there is no
h
guarantee that interference will not occur in a particular installation.
f this equipment does cause harmful interference to radio or
I
elevision reception, which can be determined by turning the
t
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The rating information is located at the bottom of the unit.
INDUSTRY CANADA NOTICE
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)
Important Safety Information
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all Instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in
accordance with the Manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
10. Only use attachments/accessories specified by the
manufacturer.
11. Unplug this apparatus during lightning storms or when unused
for long periodsof time.
12. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate
normally, or has been dropped.
13. WARNING: To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture. Do not place objects
filled with water, such as a vase, on the apparatus.
14. The AC mains plug is used as the power disconnect device and
it should remain readily accessible and operable during
intended use. In order to completely disconnect the apparatus
from power, the mains plug should be completely removed
from the AC outlet socket.
15. C AUTION: To reduce the risk of fire or explosion, do not expose
batteries to excessive heat such as sunshine, fire or other heat
sources.
1
AUDIO
INP UT
RL
REAR VIEW OF EXTERNAL UNIT
REAR VIEW
RCA cables
AUDIO OUT
(white - L
r
ed - R)
“
C” SIZE 1.5V X 4 UM-2
+–+–
+–+–
iSM395bt-ENG-v4_Layout 1 7/26/13 8:50 AM Page 3
Connection
Connecting this Unit to an External Stereo, etc.
To listen to this unit’s audio through a
stereo or other external unit, connect
as follows:
Connect the Audio cable’s red and
white plugs to the red and white
AUDIO OUT jacks on the iSM395BT
and the other ends to the external
unit’s red and white Audio In jacks.
Note
: Audio cables are not included.
Connecting a Digital Music Player to this Unit
Your Singing Machine is designed to connect your favorite digital
music device (iPod, MP3 player, etc.). Simply connect your device
by using an appropriate audio cable (3.5mm audio cable not
included). When connected, the Aux function is automatically
selected. See page 7 for more details.
Inserting Batteries
Lift battery door to reveal battery compartment.
1
Insert four (4) “C” size alkaline batteries (not
2
included) as indicated by the polarity in the
battery compartment.
Replace battery door tightly before operating.
3
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Warning – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. A reversed battery
may cause damage to the device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old batteries with fresh ones.
5. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery
6. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer’s
7. Remove batteries promptly if consumed.
8. Clean the battery contacts and also those of the device prior to battery installation.
leakage.
directions.)
3