SIM2 D-30-H, D-20-H Owners manual
DOMINO 20H
DOMINO 30H
DLP™ VIDEO
PROJECTOR
RS-232C
CONTROL
SPECIFICATIONS
Document Revision 1.1 (20 July 2004)
SIM2 DOMINO 20H / DOMINO 30H
RS-232C CONTROL SPECIFICATIONS
Table of Contents
1. INTRODUCTION 3
CONNECTION 3
2.
3.
COMMUNICATION PROTOCOL 4
EADER 4
H
P
AYLOAD 4
COMMANDS 5
4.
EMOTE CONTROL KEYCODES 5
R
PERATION CODES 7
O
EXAMPLES 9
5.
6.
WARNINGS 10
Revision History:
Revision Date Software Version Description of Change
1.1 20 July 2004 2.36.09 F or higher Auto Sync on Inputs 5/6/7/8 added.
1.0 20 April 2004 2.33.00 F or higher Initial version.
2
SIM2 DOMINO 20H / DOMINO 30H
RS-232C CONTROL SPECIFICATIONS
1. Introduction
This document describes the communication and data formats used to control SIM2 DOMINO 20H /
DOMINO 30H
projectors via RS-232C port.
2. Connection
Switch off your Personal Computer and Projector before connecting RS 232C cable.
Use a standard serial cable with 9 pin female to the Personal Computer and 9 pin male to the Projector: pin
2 connects to pin2, pin 3 to pin 3 and pin 5 to pin 5.
SIM2 DOMINO 20H / DOMINO 30H RS-232C Port is described as follows.
SIM2 DOMINO 20H / DOMINO 30H RS-232C Control Port:
D-SUB 9-pin
(female)
51
96
Pin No Signal Definition
1 N/A Not used
2 TD Transmit data
3 RD Receive data
4 N/A Not used
5 GND Ground
6 N/A Not used
7 N/A Not used
8 N/A Not used
9 N/A Not used
Switch on the Personal Computer and, after start up, switch on the Projector.
Load a suitable communication software onto your Personal Computer, and set the Serial Port Parameters as
shown below.
Communication Parameters:
Parameter Value
Transfer Rate 19200 bps
Data Bits 8
Parity Bit None
Stop Bit 1
Flow Control None
Set Send Mode and Read Mode to HEX.
3
Loading...