Silverline Ear Plugs User Manual

ensure the plugs are not accessible to children.

• These ear plugs are single use, discard after use to

sealed the ear canal.

the plugs are not accessible to children.

33.2 31.6 33.1 33.5 33.8 43.3 41.4

4.9 6.3 6.5 4.2 3.5 5.1 4.5

38.1 37.9 39.6 37.7 37.3 48.4 45.9

125 250 500 1000 2000 4000 8000

• These ear plugs are single use, discard after use ensure
injury, do not provide unlimited protection.

• These ear plugs, whilst designed to protect ears from
permanent deafness.
noise may lead to serious injury, temporary or
as gunfire. Constant or repetitive exposure to impulsive
of the protection attainable against impulsive noise such
continuous noise and may not be an accurate indicator
Noise Reduction (SNR) is based on the attenuation of
the harmful effects of impulsive noise. The Standard

• Ear Plugs can be recommended for protection against

• Follow these instructions for proper fit.
reduce noise levels.

• Improper fit of this device will reduce its effectiveness to

WARNING

EN ISO 4869-2 SNR-value: SNR 37dB
EN ISO 4869-2 HML value: H=36 M=34 L=33

Tested according to EN352-1:2002

(dB)
Protection Value
Assumed

Deviation (dB)
Standard

Attenuation (dB)
Mean

Frequency Hz

Attenuation values

SPECIFICATION

Ear Plugs

Product

• Hold in place until ear plug has expanded to fit and

ear upward to open the canal.
canal reach over your head with one hand and pull the

• Carefully place into the ear canal. To help open the ear

expel air.

• Roll the ear plugs between the fingers to soften and

Operating Instructions

OPERATING INSTRUCTIONS

Familiarisation

should be correctly repaired or replaced.
Any guard or other part that is damaged
Check alignment of moving parts for binding.
properly and perform its intended operation.
further use, check carefully that it will operate

• If any part of the tool is damaged, before

Check damaged parts

its stand to reach them.
so that it is necessary to stand on the tool or
Do not store materials above or near the tool
or if the cutting tool is accidentally contacted.
could cause serious injury if the tool is tipped

• Standing on your power tool or its stand

Never stand on your power tool

accessories could be dangerous.
the accessories. The use of improper

• Follow the instructions that accompany

Accessories

changing accessories and lubrication.
safest performance. Follow instructions for
keep tools sharp and clean for best and

• Keep your tool in good working order,

Maintain your tool

times to ensure correct balance.

• Do not over reach, keep proper footing at all

Keep your balance

hands to operate your power tool.
clamp or vice, it will allow you to use both

• Always secure work where practical, use a

Secure work

operation.
protectors during extended periods of
operation is likely to be dusty and ear
shatter. Use face or dust mask if
as lenses are not impact resistant and could
glasses are not sufficient for eye protection,

• Wear safety goggles at all times, every day

Protect your head

sleeves above the elbow.
footwear, cover or tie back long hair, roll long
caught in moving parts. Wear non-slip
jewellery or other items which may get

• Do not wear loose clothing, neckties or

Wear correct clothing

for a purpose it was not designed for.

• Do not force, or attempt to use a power tool

Use the correct power tool

when using it.
service if you do not use excessive force

• Your power tool will give you much better

Do not use excess force.

children can not get access to them.
workshop child-proof. Lock tools away where
distance from your work. Make your

• Children should always be kept at a safe

Children

area well lit.
adequate surrounding work space and keep
conditions, or expose them to rain. Provide

• Do not use power tools in damp or wet

Dangerous environment

slippery due to sawdust or wax.
kept clear, avoid working where the floor is
areas are cluttered or dirty, floors must be

• Accidents occur where benches and work

Clean work area

before turning on.
wrenches are removed from power tool

• Always check to see that keys and adjusting

Remove adjusting keys

without any guard supplied with it.
aligned. Never attempt to use a power tool
working order, correctly adjusted and

• Always keep guards in position, in good

Keep guards in position

terminal.
to the earth terminal never connect it to a live
cable. Always connect the green and yellow

• Where the tool is supplied with a 3 core

Earth all tools

hazards associated with this power tool.
application, as well as it’s limitations and the potential
manual and any label attached to the tool. Learn its
It is important to read and understand your instruction

GENERAL SAFETY INSTRUCTIONS

Thank you for choosing this product.

Silverline Tools Ltd. guarantees this product to be free of defects in material & workmanship forever. Any defective
product returned, with original receipt, will be repaired, replaced or refunded at our discretion. We do not refund
carriage. This guarantee does not cover damage caused by abuse, misuse, modification, accident or fair wear &

If you experience a problem, return the product direct to us, with the original receipt at :

We do not refund carriage. This guarantee is for Great Britain only and does not affect your

tear. Your statutory rights are not affected.

Silverline Tools Limited.

PO Box 2988,

Yeovil.

BA21 1WU

statutory rights. As you would expect fair wear and tear are not covered.

Ear Plugs

Product Code 675240

© July 2006