Siemens TMM-1 Installation Instructions Manual

Installation Instructions
Model TMM-1 Telephone Master Module
INTRODUCTION
The optional Model TMM-1 Telephone Master Module from Siemens Industry, Inc. provides firefighters with an emergency telephone system for communications with remote loca­tions. The TMM permits five telephones to be off-hook at the same time with minimal loss of quality in the sound. This module also has a warden’s page feature that permits paging through the speaker zones from the master telephone as well as from remote locations. (See Figure 1.)
The push-to-talk button on the TMM-1 Tele­phone Master module connects the red master telephone to the MXLV system through the telephone riser. It also provides the signal for the warden’s page. The warden’s page is controlled by the ACM-1 and selected by a VSM-1 module. For more information about the MXLV system, refer to the MXL/MXLV Manual, P/N 315-092036.
Figure 1
TMM-1 Module
INSTALLA TION
(Refer to Figure 2)
To mount the TMM-1 module:
1. Mount the TMM-1 on the MKB-2 panel to the right side of the keyboard/annunciator display (as viewed from the front).
2. Remove the black filler plate on the right side of the keyboard/annunciator display and discard.
Siemens Industry, Inc. Building Technologies Division Florham Park, NJ
P/N 315-092099-6
3. From the front of the panel, insert the TMM-1 studs through the holes in the MKB-2 panel, and from the rear of the panel secure the studs with the three No. 8 nuts supplied.
4. Mount the electronics assembly to the rear of the TMM-1 housing by placing it over the four snap studs on the side of the rear. Be sure that the 14 pin connector (P3) is at the bottom of the assembly. Then press down on the board to seat it firmly. (Refer to Figure 3.)
Siemens Building Technologies, Ltd. Fire Safety & Security Products 2 Kenview Boulevard Brampton, Ontario L6T 5E4 Canada
INSTALLING THE TMM-1
(Refer to Figure 2)
Install the cables from the module to the paired connectors as follows:
1. Connect the two wire cable from the hole at the rear of the telephone housing to P2 on the left of the PC board mounted on the TMM.
2. Connect the four wire cable provided (P/N 600-180364) between P1 at the top of the TMM-1 PC board and P5 on the TBM-1, which is located on the right in the system backbox.
3. Connect the 14 position ribbon cable provided (P/N 555-192236) between P3 on the TMM-1 and P1 on the adjacent ACM-1 module.
ELECTRICAL RATINGS
tnerruCeludoMCDV5evitcAAm0
tnerruCeludoMCDV42evitcAAm14
tnerruCeludoMCDV42ybdnatSAm02
Figure 2
Mounting the TMM-1 Module
P/N 315-092099-6
Figure 3
Installing the TMM-1 Module
Loading...