Siemens S6409N3GB, SE70A591GB, SE70A591 Instructions Manual

Brief and handy: everything your dishwasher needs.

Before using for the first time, still read the installation and operating instructions!

Useful information when using the appliance for the first time

Before using the appliance for the first time

– Select the display language, see operating instructions – Fill with salt and rinse aid, see below – Adjust softening system, see operating instructions

Operating principle, display with buttons:

Main menu:

– Clear text provides information about possible settings, operations – Arrows identify the buttons which can be pressed – Buttons enable settings, operations

Auto Wash

StartOptions

Turn on the tap

To switch on, press main switch .

Summary of instructions for dishwasher

Select programme

Options

Start programme Off we go

Press ”Start” in the main menu

Switch off the appliance Everything o.k.

When a buzzer has been emitted 5 times (end of programme), press the main switch .

5 600 053 917 (8301) 635D–nf

Fill with salt

Fill with rinse aid

Fill with detergent

Switch on the appliance

with /-+ in main menu

Auto Wash

Start

Not required if softening system set to “0”. Required if “Refill salt” is displayed

Unscrew the lid.

Required if “Refill rinse aid” is displayed.

Press the marking, Lift the lid

Little dirt, little cleaning agent

Quick, economical or intensive

Programme overview

The programme data is based on laboratory measured values in compliance with European standard EN 50242. Deviations are possible in practice.

Warning,

combination products are not suitable for all programmes, follow manufacturer’s instructions.

Duration in minutes Power consumption in kWh Water consumption in litres

Only before using the dishwasher for the first time pour approx. 1 l / 1 1/4 pt water into

the salt opening.

Auto

Super

Wash

100-140

1,20-1,60

16-23

Pour in max.

1.5 kg / 3 lb 5 oz salt (never detergent!)

Pour in the rinsing agent

Pour in the

cleaning agent

Auto Wash

100-160

1,00-1,30

12-20

Options/standard settings Standard programmes

Select with “Options”, adjust with –/+, save with main menu/“Options”:

1. Timer programming

2. Reduce time

3. Degree of dryness

4. Buzzer volume

5. Water hardness

6. Rinse aid dosage

7. Language

8. Standard programmes

Duration in minutes Power consumption in kWh Water consumption in litres

Normal

Extra

135

0,65

Auto

Delicate

Wash

80-110

0,80-1,10

10-17

Normal

1,05

Eco

150

Screw on the lid. Switch on dishwasher immediately.

Close the lid. CLICK

Push the lid too, press. PLOP

Quick Wash

Prerinse

0,60

Normal Normal

140

1,05

only

0,10

Plus

140

1,05

Maintenance and care

For perfect rinsing results

Filters

Check and, if required, clean:

Spray arms

Remove blockages/ deposits

Pull up lower arm Unscrew upper arm Clean under running

Troubleshooting

Fault Possible causes

Wrong language displayed

Programme does not start/does not continue ... Residual water in the appliance ...

Language adjusted

Programme has not been started ... Door is open or was opened before end of programme ...

Rotate filter cylinder, remove filter system

Dealing with problems correctly ...

Remedial action

Switch off the appliance. Switch on the appliance by holding down the main switch until the display illuminates. Select the language.

If required, start the programme. Close the door, wait until the

programme ends (buzzer emitted 5 times).

Rinse under running water

water (if required, use a toothpick)

Fault Possible causes Remedial action

Plastic parts/utensil parts discoloured ...

Milky deposits on the utensils (removable) ...

Detergent with lower bleaching effect ... Insufficient detergent ...

Rinse aid dosage too high (visible streaking) ... Rinse aid dosage too low ...

Insert Screw on filter

Insert lower arm Screw on upper arm

Use detergent with chlorine bleaching. Comply with manufacturer’s specifications.

Reduce or increase dosage according to instructions.

system. NOTE MARK!

Appliance does not run/ stops ...

Utensils are not clean ...

Sand or gritty residue on the utensils ...

No/insufficient water check whether ...

Utensils close together/on top of each other ... Insufficient detergent ... Unsuitable programme ... Spray arms blocked ...

Filters loose ... Filters dirty ...

Spray arm nozzles blocked ... Insufficient water ...

Turn on the water supply. Supply fittings unobstructed and not calcified. Supply hose kink-free.

Arrange utensils according to instructions. Comply with manufacturer’s specifications, select suitable programme. Re-arrange obstacles (e.g. large spoons).

Clean filters (see above), attach correctly (MARK). Clean filters (see above). Clean spray arms (see above). See “Appliance does not run”.

Interrupting the programme ... Terminating the programme ...

– Open the door. – To continue the programme, close the door.

– Open the door and press the “Terminate programme” button. – Close the door and wait until the buzzer is emitted 5 times. – Restart the programme or switch off the appliance.

Glasses cloudy/ dull ...

Rust on the cutlery ...

Water too hard ... Glasses not dishwasher-proof ...

Detergent unsuitable ...

Cutlery not rust-resistant ...

Refill with salt/adjust softening system. User dishwasher-proof glasses. Use glass-friendly detergents.

Use dishwasher-proof cutlery.

Further information can be found in the operating instructions ... Self-help is worthwhile!

Arranging utensils correctly ...

Arrange dishwasher-proof utensils (having removed any ash, wax, grease or ink. Coarsely remove sticky labels, large remnants of jam, milk products or food) according to the operating instructions and check that the spray arms can rotate freely.