Seville Classics WEB342 Assembly Instructions/use And Care Manual

Step 6:

Or, if necessary, expand and separate the
unit, then reconnect it around the piping.

Step 7:

Expand the unit to the desired width and
tighten the connectors. Then snap the

PANELS (D) on the frames.

WARNING: Maximum weight capacity per panel is 4 lbs evenly

distributed. Do not sit on the unit. Do not drop heavy items on the unit.
Place heavier items on the lower shelf and lighter ones on the top shelf.
Do not move the unit while loaded.

TF150924

UNDER-THE-SINK ORGANIZER

Model No. WEB342

ASSEMBLY INSTRUCTIONS

Customer Service

Tel [phone]
Tel [phone]

Fax [phone]

Monday through Friday 9:00 am - 5:00 pm (Pacific Time)

Seville Classics, Inc.

Torrance, CA 90501 USA

www.sevilleclassics.com

Please read and save these instructions ©2015 Seville Classics, Inc.

Please make sure you have all the parts before assembling the unit.

A

4 pcs

B

8 pairs

C

2 pcs

D

10 pcs

Pole

Slip Sleeve

Frame

Panel

E

4 pcs

Leveling Foot

Step 1:

Screw the Leveling Feet (E) into the
bottoms of each Pole (A).

Step 2:
Starting from the bottom, fasten 4 pairs of
Slip Sleeves (B) around the grooves of
the 4 poles. Move the slip sleeves slightly
up or down until they snap into position.

Step 3:

Slide a Frame (C) over the poles until it
rests snugly over the slip sleeves.
Tip: If necessary, use a rubber mallet to
further secure the frame.

Step 4:
Fasten 4 pairs of slip sleeves around the
grooves at the top and slide the other frame
over the poles until it rests snugly over the
slip sleeves.
Tip: The height of the frame (slip sleeves)
can be fully adjusted at 1 inch increments to
fit the piping.

Step 5:

Tilt the unit into the cabinet and position it
under the piping.