Seville Classics UltraHD Series, WEB627, EHF10235, WEB628, WEB629 Assembly Instructions Manual

4. Bypass Switch- Shift between two functions (Sensor or pull chain) freely. Select the desired

Customer Service:

Tel [phone]
Tel [phone]

Fax [phone]

Monday through Friday

9:00 am - 4:30 pm (Pacific Time)

[e-mail]

working mode. ”━” Motion sensor mode, ”Ｏ” Pull chain mode.

5. Plug the power supply cord into the electrical outlet.

ASSEMBLY INSTRUCTIONS

UltraHD LED Shop Light

Model No.EHF10235 / WEB627 /

WEB628 /WEB629

LINKING MULTIPLE SHOP LIGHTS:

The maximum number of connected lamps is 4.

Torrance, CA 90501 USA

www.sevilleclassics.com

© 2019 Seville Classics, Inc.

MADE IN CHINA LS190307

Unpack and remove all parts from the box. If there are missing or

broken parts, please contact our CUSTOMER SERVICE.

PARTS:

X 1 LED Shop Light

X 2 Hanging Chains

x 4 “S” Hooks

x 2 Eye Hook Screws

x 6 Plastic Anchors

x 4 Screws

x 1 Cotton Rope

Rated: 120V-60Hz 40W

READ ALL THE INSTRUCTIONS AND SAVE THIS INSTRUCTION SHEET.
NOT READING THE INSTRUCTIONS MAY CAUSE RISK OF FIRE OR PERSONAL INJURY

CAUTION: To reduce the risk of fire, electric shock or injury to people:

• Suitable for damp/dry locations.

• Not for use with dimmers.

• Use only insulated staples or plastic ties to secure the cord.

• Do not install directly over a heat source (stove, etc.)

• Use safety precautions. Safety eye glasses and gloves are recommended.

• Installation should not be made on a radiant-heating ceiling.

• Injury to people and damage to the lamp and/or mounting surface may result if the lamp is

pulled from the surface. To reduce the likelihood of such injury or damage, mount only on a
mechanically sound surface.

• Please do not link other electrical appliances at the link end.

• Do not alter the plug or power supply cord in any way or try to install this product in any other

method besides method shown on this sheet.

NOTE:

1. This fixture complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

2. To install onto a plaster board surface, plaster board requires minimum 3/8” thick.

2. Install the 2 plastic anchors 47 1/4” apart, then screw the eye hook into each anchor.

47 1/4"apart