Securitron EL-CEPT-10B, EL-CEPT-04, EL-CEPT, EL-CEPT-10, CEPT-NW Installation Instructions
Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader
Tel 800.624.5625 techsupport@securitron.com
in door opening solutions
CONCEALED ELECTRICAL POWER TRANSFER SERIES CEPT
INSTALLATION INSTRUCTIONS
PRODUCT COMPATIBILITY NOTE
openings with the following door/frame/hinge configurations:
Offset Pivots Pocket Pivots Center Hung Doors
: The Securitron CEPT will NOT operate properly on
Butt Hinges over 6” Swing Clear Hinges Balanced Doors
Available CEPT Models:
CEPT-10
Traditional Connect
10 Wire (2 + 8)
(2) Wire Nut
+ (8) Crimp
EL-CEPT
ElectroLynx®
(Assa Abloy)
12 Wire (8 + 4)
Connectors: 8 Pin + 4 Pin
(TIA/EIA-568-B Compatible)
Connectors: 6 Pin + 4 Pin
CEPT-C5E
CAT 5e
9 Wire (8 + 1)
DESCRIPTION
The Concealed Electrical Power Transfer CEPT unit is designed to provide a secu re multiple wire
power and/or data transfer between a door frame and door. The unit mounts directly between
the frame and door along the hinged edge and is available in three multi-wire configurations.
The CEPT is non-handed, allows mechanical (hinged) movement of the door and is totally
concealed when the door is fully closed. This manual provides the information required to
successfully install a CEPT to a standard hinged door opening.
© Copyright, 2011, all rights reserved PN# 500-22115
Page 1 Rev. C, 05/11
Components included with this Product:
B
A
C
D
G
F
E
Item Description Quantity
A CEPT Assembly 1
B Back Box 2
C Screws, 10-24 x 3/4” Phillips Flat Head Undercut (for metal) 13
D Screws, #10 x 3/4” Phillips Flat Head (for wood) 13
E Strain Relief Bushing 2
F Wire Nut (CEPT-10 Only) 4
G Dolphin™ Connector (CEPT-10 Only) 17
RECOMMENDED TOOLS
Basic for Factory Prepped Door Install: Additional for More Detailed Install:
Hammer
Flat Tip Screwdriver: 1/4”
Phillips Screwdriver: #2
Wire Strippers/Crimpers
Pliers
Center Punch
Drill Motor & Bits
Reciprocating Saw & Blades
Router & Bits
Chisel
Metal File
SPECIFICATIONS
Physical
For proper installation and operation of the CEPT, the thickness of the door should be 1-3/4”
minimum. The door opening limitations listed here apply to a (1-3/4”) door equip ped with the
following hinge sizes and configurations.
Door Hinge Configuration:
Door Opening Angle Range:
Up to 5” Butt Hinge 0-180°
5-1/2” Butt Hinge 0-130°
6” Butt Hinge 0-110°
PN# 500-22115
Page 2 Rev. C, 05/11
Loading...